TPS76701

FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS

TPS76701

Fast-Transient-Response 1-A Low-Dropout Linear Regulators

TPS76701

FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS;

TPS76701-EP

增强型产品快速瞬态响应 1A 低压降稳压器; • Controlled Baseline \n - One Assembly/Test Site, One Fabrication Site\n• Extended Temperature Performance of –40°C to 125°C\n• Enhanced Diminishing Manufacturing Sources (DMS) Support\n• Enhanced Product Change Notification\n• Qualification Pedigree\n• 1 A Low-Dropout Voltage Regulator\n• Available in 1.5-V, 1.8-V, 2.5-V, 2.7-V, 2.8-V, 3.0-V, 3.3-V, 5.0-V Fixed Output and Adjustable Versions\n• Dropout Voltage Down to 230 mV at 1 A (TPS76750)\n• Ultralow 85 µA Typical Quiescent Current\n• Fast Transient Response\n• 2% Tolerance Over Specified Conditions for Fixed-Output Versions\n• Open Drain Power-On Reset With 200-ms Delay (See TPS768xx for PG Option)\n• 20-Pin TSSOP PowerPAD™ (PWP) Package\n• Thermal Shutdown Protection\nComponent qualification in accordance with JEDEC and industry standards to ensure reliable operation over an extended temperature range. This includes, but is not limited to, Highly Accelerated Stress Test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold compound life. Such qualification testing should not be viewed as justifying use of this component beyond specified performance and environmental limits. PowerPAD is a trademark of Texas Instruments.;

This device is designed to have a fast transient response and be stable with 10-µF low ESR capacitors. This combination provides high performance at a reasonable cost.\n Because the PMOS device behaves as a low-value resistor, the dropout voltage is very low (typically 230 mV at an output current of 1 A for the TPS76750) and is directly proportional to the output current. Additionally, since the PMOS pass element is a voltage-driven device, the quiescent current is very low and independent of output loading (typically 85 µA over the full range of output current, 0 mA to 1 A). These two key specifications yield a significant improvement in operating life for battery-powered systems. This LDO family also features a sleep mode; applying a TTL high signal to EN\\ (enable) shuts down the regulator, reducing the quiescent current to 1 µA at TJ = 25°C.\nThe RESET\\ output of the TPS767xx initiates a reset in microcomputer and microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS767xx monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage.\n The TPS767xx is offered in 1.5-V, 1.8-V, 2.5-V, 2.7-V, 2.8-V, 3.0-V, 3.3-V, and 5.0-V fixed-voltage versions and in an adjustable version (programmable over the range of 1.5 V to 5.5 V). Output voltage tolerance is specified as a maximum of 2% over line, load, and temperature ranges. The TPS767xx family is available in a 20-pin PWP package.\n \n

TPS76701-EP

FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS

TPS76701-EP

FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS

TPS76701Q

FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS

TPS76701Q

FAST TRANSIENT RESPONSE 1-A LOW DROPOUT LINEAR REGULATORS

TPS76701Q

FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT LINEAR REGULATORS

TPS76701Q

Fast-Transient-Response 1-A Low-Dropout Linear Regulators