TPS2816集成电路（IC）的栅极驱动器规格书PDF中文资料

TPS2816属于集成电路（IC）的栅极驱动器。由德州仪器制造生产的TPS2816栅极驱动器栅极驱动器电源管理集成电路 (PMIC) 可用于提供隔离、放大、参考位移、自举或其他必要功能，这些功能可将来自电源转换应用中控制设备的信号连接到电源被控制通过的半导体设备（通常为 FET 或 IGBT）。任何特定设备提供的确切功能各不相同，但与它适合驱动的半导体配置相关。

Low-Cost Single-Channel High-Speed

MOSFET Driver

ICC . . . 15-μA Max (TPS2828, TPS2829)

25-ns Max Rise/Fall Times and 40-ns Max

Propagation Delay . . . 1-nF Load

2-A Peak Output Current

4-V to 14-V Driver Supply Voltage Range;

Internal Regulator Extends Range to 40 V

(TPS2816, TPS2817, TPS2818, TPS2819)

5-pin SOT-23 Package

–40°C to 125°C Ambient-Temperature

Operating Range

Highly Resistant to Latch-ups

description

The TPS28xx single-channel high-speed MOSFET

drivers are capable of delivering peak

currents of up to 2 A into highly capacitive loads.

High switching speeds (tr and tf = 14 ns typ) are

obtained with the use of BiCMOS outputs. Typical

threshold switching voltages are 2/3 and 1/3 of

VCC. The design inherently minimizes shootthrough

current.

A regulator is provided on TPS2816 through TPS2819 devices to allow operation with supply inputs between

14 V and 40 V. The regulator output can be used to power other circuits, provided power dissipation does not

exceed package limitations. If the regulator is not required, VDD (the regulator input) should be connected to

VCC. The TPS2816 and TPS2817 input circuits include an active pullup circuit to eliminate the need for an

external resistor when using open-collector PWM controllers. The TPS2818 and TPS2819 are identical to the

TPS2816 and TPS2817, except that the active pullup circuit is omitted. The TPS2828 and TPS2829 are

identical to the TPS2818 and TPS2819, except that the internal voltage regulator is omitted, allowing quiescent

current to drop to less than 15 μA when the inputs are high or low.

The TPS28xx series devices are available in 5-pin SOT-23 (DBV) packages and operate over an ambient

temperature range of –40C to 125C.