TPPM0115D.A中文资料德州仪器数据手册PDF规格书

features

DC-DC Synchronous Buck Controller

Switching Frequency, 200 kHz (Typ)

Programmable Output Voltage,

1 V to 2.5 V ±2%

Power Good Function (PWRGD)

Input Voltage, 12 V ±5%

Drive High Load Current With External

Components

description

The TPPM0115 is a synchronous buck controller capable of driving two external power FETs 180° out of phase.

The device requires a minimum of external standard filter components and switching FETs to regulate the

desired output voltage. This is achieved with an internal switching frequency of 200 kHz (typical).

The TPPM0115 switch mode controller and associated circuitry provide efficient voltage regulation of greater

than 85%. The output voltage is set by two external resistors. During power up, when the output voltage reaches

90% of the desired value, the power good (PWRGD) output is transitioned high after a short delay of 1 ms to

5 ms. During power down, when the output voltage falls below 90% of the set value, the PWRGD output is pulled

low without any delay.

In the event the set output is in an over-voltage condition due to a system fault, the drive to the lower FET turns

on to correct the fault. There is a dead time between switching one FET ON while the other FET is switching

OFF to prevent cross conduction.

The TPPM0115 is capable of driving high static load currents with minimal ripple on the output (<2%). The phase

sense input is used to sense the flow of current through the inductor during flyback to minimize ripple on the

output.

To optimize output filter capacitance, the voltage mode control is based on a fixed ON time during the start of

the cycle and hysteretic control during load transients. This allows the device to respond and maintain the set

regulation voltage.

applications

PC Motherboard, Voltage Regulation for

System Power

DDR Memory Supply (VDDQ or VTT)

RDRAM Memory Supply (VDDQ)

General Purpose Synchronous Switch

Mode Controller