TPIC2810D.A中文资料德州仪器数据手册PDF规格书

Low rDS(on) . . . 5 Ω Typical

Eight Power DMOS Transistor Outputs of

100-mA Continuous Current

210-mA Current Limit Capability

Drain Output ESD Protection . . . 3000 V

Output Clamp Voltage . . . 40 V

description

The TPIC2810 device is a monolithic, mediumvoltage,

low-current, 8-bit shift register design to

drive low-side switched resistive loads such as

LEDs. The device is not recommended for

switching inductive loads.

This device contains an 8-bit, serial-in, parallel-out shift register that feeds an 8-bit D-type storage register. Data

transfers through the shift register via an I2C bus interface. Data is transferred into the data shift register only

after the group ID and device address have been verified. The subaddress directs the I2C bus interface to read

or write data to the device or transfer data to the output. When output enable (G) is held high, all drain outputs

are off. When G is held low, data from the output storage register is transparent to the output buffers. When data

in the output buffers is low, the DMOS transistor outputs are off. When data is high, the DMOS transistor outputs

have sink-current capability.

The TPIC2810 device has an internal power-up clear to initialize all registers to an off state when power is

applied to the device. It also has a thermal sensor to monitor the die temperature and shut the drain outputs

off, if an over current condition occurs.

Outputs are low-side, open-drain DMOS transistors with output ratings of 40 V and 100 mA continuous

sink-current capability. Each output provides a 210-mA maximum current limit at TC = 25°C. The current limit

decreases as the junction temperature increases for additional device protection. The device also provides up

to 3000 V of ESD protection on output terminals and 2000 V of ESD protection on input terminals when tested

using the human-body model.

The TPIC2810 device is characterized for operation over the operating case temperature range of −40°C to

125°C.