TPIC2603DWRG4.A中文资料德州仪器数据手册PDF规格书

Serial Control With Diagnostics

Six Power DMOS Transistor Outputs of

350-mA Continuous Current

Internal 60-V Inductive Load Clamp

Independent ON-State

Shorted-Load/Short-to-Battery Fault

Detection on All Drain Terminals

Independent OFF-State Open-Load Fault

Sense on All Drain Terminals

Transition of Drain Outputs to Low Duty

Cycle Pulsed-Width-Modulation (PWM)

Mode for Over-Current Condition

Over-Battery-Voltage-Lockout Protection

Over-Temperature Sense With Serial

Interface Fault Status

Fault Diagnostics Returned Through Serial

Output Terminal

Internal Power-On Reset of Registers

CMOS Compatible Inputs With Hysteresis

description

The TPIC2603 is a monolithic low-side driver which

provides serial interface and diagnostics to control

six on-board power DMOS switches. Each channel

has independent OFF-state open-load sense,

ON-state shorted-load/short-to-battery protection,

over-battery-voltage-lockout protection, and

over-temperature sense with fault status reported

through the serial interface. The device also

provides inductive voltage transient protection for

each drain output. The TPIC2603 drives inductive

and resistive loads such as relays, valves, and

lamps.

Serial data input (SDI) is transferred through the serial register when CS is low on low-to-high transitions of the

serial clock (SCLK). Each string of data must consist of 8 or 16 bits of data. A logic high input data bit turns the

respective output channel ON and a logic low data bit turns it OFF. CS must be transited high after all of the serial

data has been clocked into the device. A low-to-high transition of CS transfers the last six bits of serial data to

the output buffer, places the serial data out (SDO) terminal in a high-impedance state, and re-enables the fault

register. Fault data for the device is sent out the SDO terminal. The first bit of the shift register is exclusively

ORed with the fault registers. When a fault exists, the SDI data is inverted as it is transferred out of SDO. Fault

data consists of fault flags for over-temperature (bit 6) and shorted/open-load (bits 0-5) for each of the six output

channels. Fault register bits are set or cleared asynchronously, when CS is high to reflect the current state of

the hardware. The fault must be present when CS is transited from high to low to be captured and reported in

the serial fault data. New faults cannot be captured in the serial register when CS is low.