TMUX7308F_V04中文资料德州仪器数据手册PDF规格书

1 Features

• Wide supply range:

– Dual supply: ±5 V to ±22 V

– Single supply: 8 V to 44 V

• Integrated fault protection:

– Overvoltage protection, source to supplies or

source to drain: ±85 V

– Overvoltage protection: ±60 V

– Powered-off protection: ±60 V

– Non-fault channels continue to operate

– Known state without logic inputs present

– Output clamped to the supply in overvoltage

condition

• Latch-up immune

• 1.8-V Logic capable

• Fail-safe logic: up to 44 V independent of supply

• Integrated pull-down resistor on logic pins

• Break-before-make switching

• Industry standard TSSOP and

smaller WQFN packages

2 Applications

• Factory automation and control

• Programmable logic controllers (PLC)

• Analog input modules

• Semiconductor test equipment

• Battery test equipment

• Servo drive control module

• Data acquisition systems (DAQ)

3 Description

The TMUX7308F and TMUX7309F are modern

complementary metal-oxide semiconductor (CMOS)

analog multiplexers in 8:1 (single ended) and 4:1

(differential) configurations. The devices work well

with dual supplies (±5 V to ±22 V), a single supply (8

V to 44 V), or asymmetric supplies (such as VDD = 12

V, VSS = –5 V). The overvoltage protection is available

in powered and powered-off conditions, making the

TMUX7308F and TMUX7309F devices suitable for

applications where power supply sequencing cannot

be precisely controlled.

The device blocks fault voltage up to +60 V or –60

V relative to ground in both powered and powered-off

conditions. When no power supplies are present, the

switch channels remain in the OFF state regardless of

switch input conditions and logic control status. Under

normal operation conditions, if the analog input signal

level on any Sx pin exceeds the supply voltage (VDD

or VSS) by a threshold voltage (VT), the channel turns

OFF and the Sx pin becomes high impedance. When

the fault channel is selected, the drain pin (D or Dx) is

pulled to the supply (VDD or VSS) that was exceeded.

The low capacitance, low charge injection, and

integrated fault protection enables the TMUX7308F

and TMUX7309F devices to be used in front end

data acquisition applications where high performance

and high robustness are both critical. The devices are

available in a standard TSSOP package and smaller

WQFN package (ideal if PCB space is limited).