TMAG5110B2AQDBVRQ1传感器变送器的磁性传感器-开关（固态）规格书PDF中文资料

1 Features

• AEC-Q100 qualified with the following results:

– Device temperature grade 1: –40°C to 125°C

ambient operating temperature range

– Device HBM ESD classification Level H3A

– Device CDM ESD classification Level C6

• Functional Safety-Capable

– Documentation available to aid functional safety

system design

• 2D sensing with planar and vertical hall sensors

• Inherent quadrature independent of magnet

alignment or magnet pole pitch

• Two functional options available:

– TMAG5110-Q1: independent 2D outputs

– TMAG5111-Q1: speed and direction outputs

• Ultra-high magnetic sensitivity:

– TMAG511xx2-Q1: ±1.4mT (typical)

– TMAG511xx4-Q1: ±3mT (typical)

• Fast 40kHz sensing bandwidth

• 2.5V to 38V operating VCC range

• Open-drain output (10mA sink)

• Wide ambient operating temperature range:

– –40°C to +125°C

• Protection features

– Reverse supply protection (up to –20V)

– Device survives up to 40V

– Output short-circuit protection

– Output current limitation

2 Applications

• Incremental rotary encoding

• Linear speed and direction control

– Roof and trunk motor control

– Window and door motor control

• Angular position detection

– Knob control (radio and climate control)

– Electronic power steering

– Fluid measurement

• Angular speed and direction

– Electric pumps

– Fans

– Wheel and motor speed

3 Description

The TMAG5110-Q1 and TMAG5111-Q1 are

2-dimensional, dual Hall-effect latches operating from

a 2.5V to 38V power supply. Designed for highspeed

and high-temperature motor applications, these

devices are optimized for applications leveraging

rotating magnets. Integrating two sensors and two

separate signal chains the TMAG511x-Q1 offers

two independent digital outputs giving speed and

direction calculation (TMAG5111-Q1) or giving directly

the digital output of each independent latches

(TMAG5110-Q1). This high level of integration allows

the use of a single TMAG511x-Q1 device instead of

two separate latches.

The device is offered in a standard 3mT operating

point, as well as a high-sensitivity 1.4mT operating

point. The higher magnetic sensitivity provides

flexibility in low-cost magnet selection and mechanical

component placement. The TMAG511x-Q1 is also

available in three 2-axis combination options (X-Y,

Z-X, Z-Y) to allow flexible placement of the sensor

relative to the magnet.

The device performs consistently across a wide

ambient temperature range of –40°C to +125°C.