TLK2711HFG/EM.A中文资料德州仪器数据手册PDF规格书

1 Features

• 1.6Gbps to 2.5Gbps (Gigabits per second)

serializer/deserializer

• Hot-plug protection

• High-performance 68-pin ceramic quad flat pack

package (HFG)

• Low-power operation

• Programmable preemphasis levels on serial output

• Interfaces to backplane, copper cables, or optical

converters

• On-chip 8-bit/10-bit encoding/decoding, comma

detect

• On-chip PLL provides clock synthesis from lowspeed

reference

• Low power: < 500mW

• 3V tolerance on parallel data input signals

• 16-bit parallel TTL-compatible data interface

• Designed for high-speed backplane interconnect

and point-to-point data link

• Military temperature range (–55°C to 125°C Tcase)

• Loss-of-Signal (LOS) detection

• Integrated 50Ω termination resistors on RX

• Engineering evaluation (/EM) samples are

available 1

2 Applications

• Point-to-Point High-Speed I/O

• Data Acquisition

• Data Processing

3 Description

The TLK2711-SP is a member of the WizardLink

transceiver family of multigigabit transceivers,

intended for use in ultra-high-speed bidirectional

point-to-point data transmission systems. The

TLK2711-SP supports an effective serial interface

speed of 1.6Gbps to 2.5Gbps, providing up to 2Gbps

of data bandwidth.

The primary application of the TLK2711-SP is to

provide high-speed I/O data channels for point-topoint

baseband data transmission over controlled

impedance media of approximately 50Ω. The

transmission media can be printed circuit board,

copper cables, or fiber-optic cable. The maximum rate

and distance of data transfer is dependent upon the

attenuation characteristics of the media and the noise

coupling to the environment.

This device can also be used to replace parallel data

transmission architectures by providing a reduction in

the number of traces, connector pins, and transmit/

receive pins. Parallel data loaded into the transmitter

is delivered to the receiver over a serial channel,

which can be a coaxial copper cable, a controlled

impedance backplane, or an optical link. It is then

reconstructed into its original parallel format. It offers

significant power and cost savings over parallel

solutions, as well as scalability for higher data rates

in the future.

The TLK2711-SP performs parallel-to-serial and

serial-to-parallel data conversion. The clock extraction

functions as a physical layer (PHY) interface device.

The serial transceiver interface operates at a

maximum speed of 2.5Gbps. The transmitter latches

16-bit parallel data at a rate based on the supplied

reference clock (TXCLK). The 16-bit parallel data is

internally encoded into 20 bits using an 8-bit/10-bit

(8b/10b) encoding format. The resulting 20-bit word

is then transmitted differentially at 20× the reference

clock (TXCLK) rate. The receiver section performs

the serial-to-parallel conversion on the input data,

synchronizing the resulting 20-bit wide parallel data

to the recovered clock (RXCLK). It then decodes the

20-bit wide data using the 8-bit/10-bit decoding format

resulting in 16 bits of parallel data at the receive data

pins (RXD0–RXD15). The outcome is an effective

data payload of 1.28Gbps to 2Gbps (16 bits data ×

the frequency).

The TLK2711-SP is available in a 68-pin ceramic

nonconductive tie-bar package (HFG).