TLC59116ITPWTQ1集成电路（IC）的LED驱动器规格书PDF中文资料

TLC59116ITPWTQ1属于集成电路（IC）的LED驱动器。由德州仪器制造生产的TLC59116ITPWTQ1LED 驱动器器件属于 LED 驱动器电源管理集成电路 (PMIC) 系列，可通过标称固定电压的电源为负载（通常为发光二极管）提供电流，并且电流可控。它与用于电压调节的类似产品的主要区别在于，这类器件提供较低的反馈电压（以提高系统能效），而且通常可对器件工作点进行外部控制，可在照明应用中用于实现调光功能。

1 Features

• 16 LED Drivers (Each Output Programmable at

Off, On, Programmable LED Brightness, or

Programmable Group Dimming and Blinking

Mixed With Individual LED Brightness)

• 16 Constant-Current Output Channels

• 256-Step (8-Bit) Linear Programmable Brightness

Per LED Output Varying From Fully Off (Default)

to Maximum Brightness Using a 97-kHz PWM

Signal

• 256-Step Group Brightness Control Allows

General Dimming [Using a 190-Hz PWM Signal

From Fully Off to Maximum Brightness (Default)]

• 256-Step Group Blinking With Frequency

Programmable From 24-Hz to 10.73 s and Duty

Cycle From 0% to 99.6%

• Four Hardware Address Pins Allow 14 TLC59116-

Q1 Devices to Be Connected to Same I2C Bus

• Four Software-Programmable I2C Bus Addresses

(One LED Group Call Address and Three LED

Sub Call Addresses) Allow Groups of Devices to

Be Addressed at Same Time in Any Combination

• Software Reset Feature (SWRST Call) Allows

Device to Be Reset Through I2C Bus

• Up to 14 Possible Hardware-Adjustable Individual

I2C Bus Addresses Per Device, So That Each

Device Can Be Programmed

• Open-Load and Overtemperature Detection Mode

to Detect Individual LED Errors

• Output State Change Programmable on

Acknowledge or Stop Command to Update

Outputs Byte-by-Byte or All at Same Time (Default

to Change on Stop)

• Output Current Adjusted Through an External

Resistor

• Constant Output Current Range: 5-mA to 120-mA

• Maximum Output Voltage: 17 V

• 25-MHz Internal Oscillator Requires No External

Components

• 1-MHz Fast-mode Plus (FMT) Compatible I2C-Bus

Interface With 30-mA High-Drive Capability on

SDA Output for Driving High-Capacitive Buses

• Internal Power-On Reset

• Noise Filter on SCL and SDA Inputs

• No Glitch on Power-Up

• Active-Low Reset

• Supports Hot Insertion

• Low Standby Current

• 3.3 V or 5 V Supply Voltage

• 5.5 V Tolerant Inputs

• 28-Pin Thin Shrink Small-Outline Package

(TSSOP) (PW-28)

• –40°C to +105°C Operation

2 Applications

• General LED Lighting Applications

• Backlight for center stack buttons

• Backlight for cluster indicators

3 Description

The TLC59116-Q1 is an I2C-Bus controlled 16-

channel LED driver that is optimized for

red/green/blue/amber (RGBA) color mixing and

backlight application. Each LED output has its own 8-

bit resolution (256 steps) fixed-frequency individual

PWM controller that operates at 97-kHz, with a duty

cycle that is adjustable from 0% to 99.6%.