TL5

Max. load 800N (push)

GeneralFeatures Max.load800N(push) Max.speedatmax.load20mm/s Max.speedatnoload36mm/s Retractedlength560mm Dimensionofoutertube120*70mmrectangular Stages3-stage Stroke675mm OutputsignalsHallsensors Voltage24VDC,24VPTC Currentatratedload5A ColorBlack,wh

TL5

差分振荡器;

ETC

TL5001

PULSE-WIDTH-MODULATION CONTROL CIRCUITS; • Complete PWM power control   \n• 3.6-V to 40-V operation \n• Internal under voltage-lockout circuit \n• Internal short-circuit protection \n• Oscillator frequency : 20kHz to 500kHz \n• Variable dead timer provides control over total range;

The UTC TL5001 incorporates on a single monolithic chip all the functions required for a pulse width modulation (PWM) control circuit. Designed primarily for power-supply control, It contains an error amplifier, a regulator, an oscillator, a PWM comparator with a dead-time-control input, undervoltage lockout (UVLO), short-circuit protection (SCP), and an open-collector output transistor. The error-amplifier common-mode voltage ranges from 0V to 1.5V.The noninverting input of the error amplifier is connected to a 1-V reference. Dead-time control (DTC) can be set to provide 0% to 100% dead time by connecting an external resistor between DTC and GND. The oscillator frequency is set by terminating RT with anexternal resistor to GND. During low Vcc conditions, the UVLO circuit turns the output off until Vcc recovers to its normal operating range.

TL5001

具有宽输入范围、基准容差为 ±5%、工作温度范围为 –20°C 至 85°C 的 PWM 控制器; • Complete PWM Power Control\n• 3.6-V to 40-V Operation\n• Internal Undervoltage-Lockout Circuit\n• Internal Short-Circuit Protection\n• Oscillator Frequency . . . 20 kHz to 500 kHz\n• Variable Dead Time Provides Control Over Total Range\n• ±3% Tolerance on Reference Voltage (TL5001A)\n• Available in Q-Temp Automotive        HighRel Automotive Applications        Configuration Control / Print Support        Qualification to Automotive Standards;

The TL5001 and TL5001A incorporate on a single monolithic chip all the functions required for a pulse-width-modulation (PWM) control circuit. Designed primarily for power-supply control, the TL5001/A contains an error amplifier, a regulator, an oscillator, a PWM comparator with a dead-time-control input, undervoltage lockout (UVLO), short-circuit protection (SCP), and an open-collector output transistor. The TL5001A has a typical reference voltage tolerance of ±3% compared to ±5% for the TL5001.\n\n The error-amplifier common-mode voltage ranges from 0 V to 1.5 V. The noninverting input of the error amplifier is connected to a 1-V reference. Dead-time control (DTC) can be set to provide 0% to 100% dead time by connecting an external resistor between DTC and GND. The oscillator frequency is set by terminating RT with an external resistor to GND. During low VCC conditions, the UVLO circuit turns the output off until VCC recovers to its normal operating range.\n\n The TL5001C and TL5001AC are characterized for operation from –20°C to 85°C. The TL5001I and TL5001AI are characterized for operation from –40°C to 85°C. The TL5001Q and TL5001AQ are characterized for operation from –40°C to 125°C. The TL5001M and TL5001AM are characterized for operation from –55°C to 125°C.

TL5001

PULSE-WIDTH-MODULATION CONTROL CIRCUITS

DESCRIPTION TheUTCTL5001incorporatesonasinglemonolithicchipallthefunctionsrequiredforapulsewidthmodulation(PWM)controlcircuit.Designedprimarilyforpower-supplycontrol,Itcontainsanerror amplifier,aregulator,anoscillator,aPWMcomparatorwithadead-time-control

TL5001-D08-T

PULSE-WIDTH-MODULATION CONTROL CIRCUITS

DESCRIPTION TheUTCTL5001incorporatesonasinglemonolithicchipallthefunctionsrequiredforapulsewidthmodulation(PWM)controlcircuit.Designedprimarilyforpower-supplycontrol,Itcontainsanerror amplifier,aregulator,anoscillator,aPWMcomparatorwithadead-time-control

TL5001L-D08-T

PULSE-WIDTH-MODULATION CONTROL CIRCUITS

DESCRIPTION TheUTCTL5001incorporatesonasinglemonolithicchipallthefunctionsrequiredforapulsewidthmodulation(PWM)controlcircuit.Designedprimarilyforpower-supplycontrol,Itcontainsanerror amplifier,aregulator,anoscillator,aPWMcomparatorwithadead-time-control

TL5001L-S08-R

PULSE-WIDTH-MODULATION CONTROL CIRCUITS

DESCRIPTION TheUTCTL5001incorporatesonasinglemonolithicchipallthefunctionsrequiredforapulsewidthmodulation(PWM)controlcircuit.Designedprimarilyforpower-supplycontrol,Itcontainsanerror amplifier,aregulator,anoscillator,aPWMcomparatorwithadead-time-control

TL5001L-S08-T

PULSE-WIDTH-MODULATION CONTROL CIRCUITS

DESCRIPTION TheUTCTL5001incorporatesonasinglemonolithicchipallthefunctionsrequiredforapulsewidthmodulation(PWM)controlcircuit.Designedprimarilyforpower-supplycontrol,Itcontainsanerror amplifier,aregulator,anoscillator,aPWMcomparatorwithadead-time-control

TL5001-S08-R

PULSE-WIDTH-MODULATION CONTROL CIRCUITS

DESCRIPTION TheUTCTL5001incorporatesonasinglemonolithicchipallthefunctionsrequiredforapulsewidthmodulation(PWM)controlcircuit.Designedprimarilyforpower-supplycontrol,Itcontainsanerror amplifier,aregulator,anoscillator,aPWMcomparatorwithadead-time-control