TEA19051BTK中文资料TEA19051BTK - QC4.0+ type C controller for SMPS数据手册恩XP规格书

描述 Description

The TEA19051BTK is a secondary side SMPS controller that supports the followingprotocols:
USB Type-C v.1.2
USB Power Delivery (USB-PD) including Programmable Power Supply (PPS)
Battery Charging 1.2 (BC1.2)
Qualcomm® QuickChargeTM QC2.0, QC3.0, and QC4.0
Three types of the TEA19051BTK are available:TEA19051BATK for 27.5 W applications
The TEA19051BTK variants are available in an HVSON16 package.
In combination with the TEA193x primary controller and the TEA199x secondary-sideSynchronous Rectifier (SR) controller, a Switch Mode Power Supply (SMPS) can be built.
The SMPS has a small form factor and ultra-high efficiency over the entire load range.This power supply has an extremely low no-load input power (< 30 mW). It meetsefficiency requirements like CoC Tier-2, EuP lot 6, and DOE v6. The complete SMPSsystem can be built with a minimum number of external components and at low cost. TheTEA19051BTK offers a flexible platform which can be configured in the production lineof the SMPS by changing MTP settings. The complete SMPS system can be built with aminimum number of external components and at low cost.
The TEA19051BTK has a high level of digital integration. It incorporates all circuits,including a charge pump to drive an external NMOS load switch directly. It alsoincorporates a PHY protocol engine and an integrated driver for fast output discharge.The output voltage and output current are continuously measured. They are used todrive the SMPS. An NTC pin can continuously measure the adapter temperature orthe temperature in the cable/connector. Optionally, the NTC pin can also be used forother features, like supply (see Table 4). The die temperature of the TEA19051BTK ismeasured and protected via an internal temperature sensor.
The TEA19051BTK provides the best-in-class charging safety. To ensure the safeoperation of the SMPS, the IC incorporates all required protections. These protectionscover up to 19 different failure use cases (see Section 2.3).To ensure correct operation under all conditions, all protections are implemented inhardware. So, when the microcontroller stops, the protections are still functional. Theresponse of these protections can be programmed as latched or safe restart. Althoughnot recommended, these protections can also be disabled individually via the settings inthe non-volatile Multi-Time Programmable (MTP) memory.If an output short circuit occurs, the power dissipation from the mains input in the adapteris less than 50 mW.
For output voltage, current regulation, and protection, only a single optocoupler isrequired in the application.The TEA19051BTK operates in CV mode with a better than 2 % voltage accuracy. In CCmode, it operates with a better than 2 % full-load current accuracy.For evaluation and verification purposes of the firmware, an external EEPROM can beconnected. From the EEPROM, new firmware can be uploaded and executed.