TDA9113中文资料意法半导体数据手册PDF规格书

DESCRIPTION

The TDA9113 is a monolithic integrated circuit as sembled in a 32-pin shrink dual-in-line plastic package. This IC controls all the functions related to horizontal and vertical deflection in multimode or multi-frequency computer display monitors.

The internal sync processor, combined with the powerful geometry correction block, makes the TDA9113 suitable for very high performance monitors, using few external components.

Combined with other ST components dedicated for CRT monitors (microcontroller, video preamplifier, video amplifier, OSD controller) the TDA9113 allows fully I2C bus-controlled computer display monitors to be built with a reduced number of external components.

FEATURES

General

■ ADVANCED I2C BUS CONTROLLED

DEFLECTION PROCESSOR DEDICATED FOR HIGH-END CRT MONITORS

■ SINGLE SUPPLY VOLTAGE 12V

■ VERY LOW JITTER

■ DC/DC CONVERTER CONTROLLER

■ ADVANCED EW DRIVE

■ ADVANCED ASYMMETRY CORRECTIONS

■ AUTOMATIC MULTISTANDARD SYNCHRONIZATION

■ 2 DYNAMIC CORRECTION WAVEFORM OUTPUTS

■ X-RAY PROTECTION AND SOFT-START &

STOP ON HORIZONTAL AND DC/DC DRIVE OUTPUTS

■ I2C BUS STATUS REGISTER

Horizontal section

■ 150 kHz maximum frequency

■ Corrections of geometric asymmetry:

Pin cushion asymmetry, Parallelogram

■ Tracking of asymmetry corrections with vertical size and position

■ Fully integrated horizontal moiré cancellation

Vertical section

■ 200 Hz maximum frequency

■ Vertical ramp for DC-coupled output stage with

adjustments of: C-correction, S-correction for

super-flat CRT, Vertical size, Vertical position

■ Vertical moiré cancellation through vertical ramp waveform

■ Compensation of vertical breathing with EHT variation

EW section

■ Symmetrical geometry corrections: Pin cushion,

Keystone, Top/Bottom corners separately

■ Horizontal size adjustment

■ Tracking of EW waveform with Vertical size and

position and adaptation to frequency

■ Compensation of horizontal breathing through

EW waveform

Dynamic correction section

■ Generates waveforms for dynamic corrections

like focus, brightness uniformity, ...

■ 1 output with vertical dynamic correction

waveform

■ 1 output with horizontal dynamic correction

waveform

■ Fixed on screen by means of tracking system

DC/DC controller section

■ Step-up and step-down conversion modes

■ External sawtooth configuration

■ Bus-controlled output voltage

■ Synchronization on hor. frequency with phase

selection

■ Selectable polarity of drive signal