I2C-bus controlled 4 X 50 W power amplifier

General description The TDA8594 is a complementary quad Bridge Tied Load (BTL) audio power amplifier made in BCDMOS technology. It contains four independent amplifiers in BTL configuration. Through the I2C-bus, diagnosis of temperature warning and clipping level is fully programmable and the in

文件：290.74 Kbytes 页数：48 Pages

恩XP

I2C-bus controlled 4 X 50 W power amplifier

General description The TDA8594 is a complementary quad Bridge Tied Load (BTL) audio power amplifier made in BCDMOS technology. It contains four independent amplifiers in BTL configuration. Through the I2C-bus, diagnosis of temperature warning and clipping level is fully programmable and the in

文件：290.74 Kbytes 页数：48 Pages

恩XP

I2C-bus controlled 4 X 50 W power amplifier

General description The TDA8594 is a complementary quad Bridge Tied Load (BTL) audio power amplifier made in BCDMOS technology. It contains four independent amplifiers in BTL configuration. Through the I2C-bus, diagnosis of temperature warning and clipping level is fully programmable and the in

文件：290.74 Kbytes 页数：48 Pages

恩XP

I2C-bus controlled 4 ??50 W power amplifier

文件：469.91 Kbytes 页数：49 Pages

PHI

飞利浦

I2C-bus controlled 4 x 50 W power amplifier

The TDA8594 is a complementary quad Bridge Tied Load (BTL) audio power amplifier made in BCDMOS technology. It contains four independent amplifiers in BTL configuration. Through the I²C-bus, diagnosis of temperature warning and clipping level is fully programmable and the information available via t General\n• Operates in legacy mode (non I²C-bus) and I²C-bus mode (3.3 V and 5 V compliant)\n• Three hardware-programmable I²C-bus addresses\n• Drives 4 Ω or 2 Ω loads\n• Speaker fault detection\n• Independent short-circuit protection per channel\n• Loss of ground and open VP safe (with 200 mΩ serie;

恩XP

I²C-bus controlled 4 x 50 W power amplifier

The TDA8594 is a complementary quad Bridge Tied Load (BTL) audio power amplifier made in BCDMOS technology. It contains four independent amplifiers in BTL configuration. Through the I²C-bus, diagnosis of temperature warning and clipping level is fully programmable and the information available via t General\n• Operates in legacy mode (non I²C-bus) and I²C-bus mode (3.3 V and 5 V compliant)\n• Three hardware-programmable I²C-bus addresses\n• Drives 4 Ω or 2 Ω loads\n• Speaker fault detection\n• Independent short-circuit protection per channel\n• Loss of ground and open VP safe (with 200 mΩ serie;

恩XP