Multiple voltage regulator with battery detection

文件：95.41 Kbytes 页数：16 Pages

PHI

飞利浦

Multiple voltage regulator with battery detection

恩XP

恩智浦

Multiple voltage regulator with battery detection

文件：98.31 Kbytes 页数：16 Pages

PHI

飞利浦

Multiple voltage regulator with battery detection

文件：98.31 Kbytes 页数：16 Pages

PHI

飞利浦

Multiple voltage regulator with battery detection

文件：95.41 Kbytes 页数：16 Pages

PHI

飞利浦

带电池检测功能的多路电压稳压器

TDA3606A是一款低功耗稳压器。该器件集成：\n一个固定电压稳压器——带折返电流保护，用于为微处理器提供电源，可在负载突降条件下工作\n 一个复位信号——可实现微处理器的接口\n 电源针脚可耐受负载突降脉冲和负电源电压\n 可定义启动特性；电源电压高于7.6 V时稳压器打开，稳压器输出电压下降至2.4 V以下时关闭稳压器。 一个VP状态控制稳压器\n 负载突降时稳压器和复位输出工作\n 电源电压范围：-18 V至+50 V\n 低静态电流（关闭电池检测）\n 高纹波抑制功能\n 双路复位输出。;

恩XP

恩智浦

Multiple voltage regulator with battery detection

GENERAL DESCRIPTION\nThe TDA3606 is a low power voltage regulator. It contains:\n1. One fixed voltage regulator with a foldback current protection, intended to supply a microprocessor that also operates during load dump\n2. A reset-signal can be used to interface with the microprocessor\n3. Supply p • One VP-state controlled regulator\n• Regulator and reset outputs operate during load dump\n• Supply voltage range of−18 to +50 V\n• Low quiescent current (battery detection switched off)\n• High ripple rejection\n• Dual reset output.;

恩XP

恩智浦