TC140X180X15

STANDARD SHAFT SEALS

DESCRIPTION TheTCprofileisashaftseal composedofasinglemetalcage witharubbercoating,aprimary sealinglipwithintegratedspringand anadditionalanti-pollutionlip. APPLICATIONS Shaftsealing Engines Pumps Transmissions

TC140X185X16

STANDARD SHAFT SEALS

DESCRIPTION TheTCprofileisashaftseal composedofasinglemetalcage witharubbercoating,aprimary sealinglipwithintegratedspringand anadditionalanti-pollutionlip. APPLICATIONS Shaftsealing Engines Pumps Transmissions

TC140X185X16

STANDARD SHAFT SEALS

DESCRIPTION TheTCprofileisashaftseal composedofasinglemetalcage witharubbercoating,aprimary sealinglipwithintegratedspringand anadditionalanti-pollutionlip. APPLICATIONS Shaftsealing Engines Pumps Transmissions

TC140X200X12

STANDARD SHAFT SEALS

DESCRIPTION TheTCprofileisashaftseal composedofasinglemetalcage witharubbercoating,aprimary sealinglipwithintegratedspringand anadditionalanti-pollutionlip. APPLICATIONS Shaftsealing Engines Pumps Transmissions

TC140X200X12

STANDARD SHAFT SEALS

DESCRIPTION TheTCprofileisashaftseal composedofasinglemetalcage witharubbercoating,aprimary sealinglipwithintegratedspringand anadditionalanti-pollutionlip. APPLICATIONS Shaftsealing Engines Pumps Transmissions

TC140X250X15

STANDARD SHAFT SEALS

DESCRIPTION TheTCprofileisashaftseal composedofasinglemetalcage witharubbercoating,aprimary sealinglipwithintegratedspringand anadditionalanti-pollutionlip. APPLICATIONS Shaftsealing Engines Pumps Transmissions

TC140X250X15

STANDARD SHAFT SEALS

DESCRIPTION TheTCprofileisashaftseal composedofasinglemetalcage witharubbercoating,aprimary sealinglipwithintegratedspringand anadditionalanti-pollutionlip. APPLICATIONS Shaftsealing Engines Pumps Transmissions

TC1410

0.5A High-Speed MOSFET Drivers

GENERALDESCRIPTION TheTC1410/1410Nare0.5VCMOSbuffer/drivers.Theywillnotlatchupunderanyconditionswithintheirpowerandvoltageratings.Theyarenotsubjecttodamagewhenupto5Vofnoisespikingofeitherpolarityoccursonthegroundpin.Theycanaccept,withoutdamageorlogi

TC1410

0.5A High-Speed MOSFET Drivers

GeneralDescription TheTC1410/TC1410Nare0.5ACMOSbuffers/drivers.Theydonotlatchupunderanyconditionswithintheirpowerandvoltageratings.Theyarenotsubjecttodamagewhenupto5Vofnoisespikingofeitherpolarityoccursonthegroundpin.Theycanaccept,withoutdamageorlog

TC1410

0.5 A MOSFET Gate Driver; Latch-Up Protected: Will Withstand 500 mA Reverse Current\nInput Will Withstand Negative Inputs Up to 5 V\nESD Protected: 4 kV\nWide Operating Range: 4.5 V to 16 V\nHigh Capacitive Load Drive Capability: 500 pF in 25nsec\nShort Delay Time: 35 ns Typ.\nConsistent Delay Times With Changes in Supply Voltage\nMatched Delay Times\nWith Logic ''1'' Input: 500 µA\nWith Logic ''0'' Input: 100 µA\nLow Output Impedance: 16 Ω (Typical)\nPinout Same as TC1411/12/13;

The TC1410/1410N are 0.5 A CMOS buffer/gate drivers. They will not latch up under any conditions within their power and voltage ratings. They are not subject to damage when up to 5 V of noise spiking of either polarity occurs on the ground pin. They can accept, without damage or logic upset, up to 500 mA of current of either polarity being forced back into their output. All terminals are fully protected against up to 4 kV of electrostatic discharge. As MOSFET gate rivers, the TC1410/1410N can easily switch 500 pF gate capacitance in 25 ns with matched rise and fall times, and provide low enough impedance in both the ON and the OFF states to ensure the MOSFET’s intended state will not be affected, even by large transients. The rise and fall time edges are matched to allow driving short-duration inputs with greater accuracy.