STM8S003F3数据手册ST中文资料规格书

描述 Description

The STM8S003F3/K3 value line 8-bit microcontrollers offer 8 Kbytes of Flash program memory, plus integrated true data EEPROM. They are referred to as low-density devices in the STM8S microcontroller family reference manual (RM0016).

The STM8S003F3/K3 value line devices provide the following benefits: performance, robustness and reduced system cost.

Device performance and robustness are ensured by true data EEPROM supporting up to 100000 write/erase cycles, advanced core and peripherals made in a state-of-the-art technology at 16 MHz clock frequency, robust I/Os, independent watchdogs with separate clock source, and a clock security system.

The system cost is reduced thanks to a high system integration level with internal clock oscillators, watchdog, and brown-out reset.

Full documentation is offered as well as a wide choice of development tools.

特性 Features

• 内核
•16 MHz advanced STM8 core with Harvard architecture and 3-stage pipeline
•Extended instruction set
• Memories
•Program memory: 8 Kbyte Flash memory; data retention 20 years at 55 °C after 100 cycles
•RAM: 1 Kbyte
•Data memory: 128 bytes true data EEPROM; endurance up to 100 k write/erase cycles
• Clock, reset and supply management
•2.95 V to 5.5 V operating voltage
•Flexible clock control, 4 master clock sources
• Low-power crystal resonator oscillator
• External clock input
• Internal, user-trimmable 16 MHz RC
• Internal low-power 128 kHz RC

•Clock security system with clock monitor
•Power management
• Low-power modes (wait, active-halt, halt)
• Switch-off peripheral clocks individually
• Permanently active, low-consumption power-on and power-down reset

• Interrupt management
•Nested interrupt controller with 32 interrupts
•Up to 27 external interrupts on 6 vectors
• 计时器
•Advanced control timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization
•16-bit general purpose timer, with 3 CAPCOM channels (IC, OC or PWM)
•8-bit basic timer with 8-bit prescaler
•Auto wakeup timer
•Window and independent watchdog timers
• Communications interfaces
•UART with clock output for synchronous operation, SmartCard, IrDA, LIN master mode
•SPI interface up to 8 Mbit/s
•I2C interface up to 400 Kbit/s
• Analog to digital converter (ADC)
•10-bit ADC, ± 1 LSB ADC with up to 5 multiplexed channels, scan mode and analog watchdog
• I/Os
•Up to 28 I/Os on a 32-pin package including 21 high-sink outputs
•Highly robust I/O design, immune against current injection
• Development support
•Embedded single-wire interface module (SWIM) for fast on-chip programming and non-intrusive debugging