SP2526EN-1中文资料西伯斯数据手册PDF规格书

DESCRIPTION

The SP2526 device is a dual +3.0V to +5.5V USB Supervisory Power Control Switch ideal for

self-powered and bus-powered Universal Serial Bus (USB) applications. Each switch has low

on-resistance (80mΩtypical) and can supply 500mA minimum. The fault currents are limited

to 2.0A typical and the flag output pin for each switch is available to indicate fault conditions

to the USB controller. The 1ms soft start will eliminate any momentary voltage droop on the

upstream port that may occur when the switch is enabled in bus-powered applications. The

thermal shutdown feature will prevent damage to the device when subjected to excessive

current loads. The undervoltage lockout feature will ensure that the device will remain off

unless there is a valid input voltage present.

■ Compliant to USB Specifications

■ +3.0V to +5.5V Input Voltage Range

■ Two Independent Power Switches

■ Two Error Flag Outputs, Open Drain

■ 2.7V Undervoltage Lockout

■ 500mA Minimum Continuous Load Current Per Switch

■ 1.25A Short Circuit Current Limit

■ 140mΩMaximum On-Resistance

■ 80µA On-State Supply Current

■ 1µA Shutdown Current

■ Output Can Be Forced Higher Than Input (Off-State)

■ Thermal Shutdown

■ 1ms Soft-Start Power Up

■ Active-High Version: SP2526-1

■ Active-Low Version: SP2526-2