SN75LP1185DBR集成电路（IC）的驱动器接收器收发器规格书PDF中文资料

SN75LP1185DBR属于集成电路（IC）的驱动器接收器收发器。由德州仪器制造生产的SN75LP1185DBR驱动器，接收器，收发器该系列产品的主要功能是提供必需的硬件资源，以通过延长电缆或印制线进行通信。确切的功能会因所采用的通信协议而异，可能包括诸如瞬态抑制之类的功能，这些功能对于通信用途可能并非绝对必要，但对于可能的使用环境却是明智之选。

Single-Chip TIA/EIA-232-F Interface for

IBM PC/AT Serial Port

Designed to Transmit and Receive 4-μs

Pulses (Equivalent to 256 kbit/s)

Less Than 21-mW Power Consumption

Wide Supply-Voltage Range . . . 4.75 V to

15 V

Driver Output Slew Rates Are Internally

Controlled to 30 V/μs Max

Receiver Input Hysteresis . . . 1000 mV

Typical

TIA/EIA-232-F Bus-Pin ESD Protection

Exceeds:

– 15-kV, Human-Body Model

Three Drivers and Five Receivers Meet or

Exceed the Requirements of TIA/EIA-232-F

and ITU V.28

Complements the SN75LP196

Designed to Replace the Industry-Standard

SN75185 and SN75C185 With the Same

Flow-Through Pinout

Package Options Include Plastic

Small-Outline (DW), Shrink Small-Outline

(DB), and Dual-In-Line (N) Packages

description

The SN75LP1185 is a low-power bipolar device containing three drivers and five receivers, with 15 kV of ESD

protection on the bus pins with respect to each other. Bus pins are defined as those pins that tie directly to the

serial-port connector, including GND. The pinout matches the flow-through design of the industry-standard

SN75185 and SN75C185. The flow-through pinout of the SN75LP1185 allows easy interconnection of the

UART and serial-port connector of the IBM PC/AT and compatibles. The SN75LP1185 provides a rugged,

low-cost solution for this function with the combination of the bipolar processing and 15 kV of ESD protection.

The SN75LP1185 has internal slew-rate control to provide a maximum rate of change in the output signal of

30 V/μs. The driver output swing is nominally clamped at ±6 V to enable the higher data rates associated with

this device and to reduce EMI emissions. Even though the driver outputs are clamped, they can handle voltages

up to ±15 V without damage. All the logic inputs can accept 3.3-V or 5-V input signals.

The SN75LP1185 complies with the requirements of TIA/EIA-232-F and ITU V.28. These standards are for data

interchange between a host computer and peripheral at signaling rates up to 20 kbit/s. The switching speeds

of the SN75LP1185 support rates up to 256 kbit/s.

The SN75LP1185 is characterized for operation from 0°C to 70°C.