SN75C23243DGGR集成电路（IC）的驱动器接收器收发器规格书PDF中文资料

SN75C23243DGGR属于集成电路（IC）的驱动器接收器收发器。由德州仪器制造生产的SN75C23243DGGR驱动器，接收器，收发器该系列产品的主要功能是提供必需的硬件资源，以通过延长电缆或印制线进行通信。确切的功能会因所采用的通信协议而异，可能包括诸如瞬态抑制之类的功能，这些功能对于通信用途可能并非绝对必要，但对于可能的使用环境却是明智之选。

Single-Chip and Single-Supply Interface for

Two IBM PC/AT Serial Ports

Meet or Exceed the Requirements of

TIA/EIA-232-F and ITU v.28 Standards

Operate With 3-V to 5.5-V VCC Supply

Always-Active Noninverting Receiver

Output (ROUT2) Per Port

Operate Up To 250 kbit/s

Low Standby Current . . . 1 μA Typical

External Capacitors . . . 4 × 0.22 μF

Accept 5-V Logic Input With 3.3-V Supply

Allow for Flexible Power Down of Either

Serial Port

Serial-Mouse Driveability

RS-232 Bus-Pin ESD Protection Exceeds

±15 kV Using Human-Body Model (HBM)

Applications

− Battery-Powered Systems, Notebooks,

Laptops, Palmtop PCs, and Hand-Held

Equipment

description/ordering information

The SN65C23243 and SN75C23243 consist of

two ports, each containing three line drivers and

five line receivers, and a dual charge-pump circuit

with ±15-kV ESD protection pin to pin (serial-port

connection pins, including GND). These devices meet the requirements of TIA/EIA-232-F and provide the

electrical interface between an asynchronous communication controller and the serial-port connector. This

combination of drivers and receivers matches that needed for two typical serial ports used in an IBM PC/AT, or

compatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V

supply. In addition, these devices include an always-active noninverting output (ROUT2) per port, which allows

applications using the ring indicator to transmit data while the devices are powered down. The devices operate

at data signaling rates up to 250 kbit/s and a maximum of 30-V/μs driver output slew-rate.