SN75C1154NSR集成电路（IC）的驱动器接收器收发器规格书PDF中文资料

SN75C1154NSR属于集成电路（IC）的驱动器接收器收发器。由德州仪器制造生产的SN75C1154NSR驱动器，接收器，收发器该系列产品的主要功能是提供必需的硬件资源，以通过延长电缆或印制线进行通信。确切的功能会因所采用的通信协议而异，可能包括诸如瞬态抑制之类的功能，这些功能对于通信用途可能并非绝对必要，但对于可能的使用环境却是明智之选。

Meet or Exceed the Requirements of

TIA/EIA-232-F and ITU Recommendation

V.28

Very Low Power Consumption . . .

5 mW Typ

Wide Driver Supply Voltage . . .

±4.5 V to ±15 V

Driver Output Slew Rate Limited to

30 V/μs Max

Receiver Input Hysteresis . . . 1000 mV Typ

Push-Pull Receiver Outputs

On-Chip Receiver 1-μs Noise Filter

description/ordering information

The SN65C1164 and SN75C1154 are low-power BiMOS devices containing four independent drivers and

receivers that are used to interface data terminal equipment (DTE) with data circuit-terminating equipment

(DCE). These devices are designed to conform to TIA/EIA-232-F. The drivers and receivers of the SN65C1154

and SN75C1154 are similar to those of the SN75C188 quadruple driver and SN75C189A quadruple receiver,

respectively. The drivers have a controlled output slew rate that is limited to a maximum of 30 V/μs and the

receivers have filters that reject input noise pulses of shorter than 1 μs. Both these features eliminate the need

for external components.

The SN65C1154 and SN75C1154 have been designed using low-power techniques in a BiMOS technology.

In most applications, the receivers contained in these devices interface to single inputs of peripheral devices

such as ACEs, UARTs, or microprocessors. By using sampling, such peripheral devices usually are insensitive

to the transition times of the input signals. If this is not the case, or for other uses, it is recommended that the

SN65C1154 and SN75C1154 receiver outputs be buffered by single Schmitt input gates or single gates of the

HCMOS, ALS, or 74F logic families.