SN74LVC374A-Q1

OCTAL EDGE-TRIGGERED D-TYPE FLIP-FLOP WITH 3-STATE OUTPUTS

1FEATURES ·QualifiedforAutomotiveApplications ·ESDProtectionExceeds2000VPer MIL-STD-883,Method3015;Exceeds200V UsingMachineModel(C=200pF,R=0) ·OperatesFrom2Vto3.6V ·InputsAcceptVoltagesto5.5V ·Maxtpdof8.5nsat3.3V ·TypicalVOLP(OutputGroundBo

SN74LVC374A-Q1

汽车类具有三态输出的八路边沿 D 类触发器; • Qualified for Automotive Applications\n• ESD Protection Exceeds 2000 V Per MIL-STD-883, Method 3015; Exceeds 200 V Using Machine Model (C = 200 pF, R = 0)\n• Operates From 2 V to 3.6 V\n• Inputs Accept Voltages to 5.5 V\n• Max tpd of 8.5 ns at 3.3 V\n• Typical VOLP (Output Ground Bounce)    CC = 3.3 V, TA = 25°C\n• Typical VOHV (Output VOH Undershoot)    >2 V at VCC = 3.3 V, TA = 25°C\n• Supports Mixed-Mode Signal Operation on All Ports (5-V Input/Output Voltage With 3.3-V VCC)\n• Ioff Supports Partial-Power-Down Mode Operation;

The SN74LVC374A octal edge-triggered D-type flip-flop is designed for 2.7-V to 3.6-V VCC operation.\n This device features 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. This device is particularly suitable for implementing buffer registers, input/output (I/O) ports, bidirectional bus drivers, and working registers.\n On the positive transition of the clock (CLK) input, the Q outputs are set to the logic levels set up at the data (D) inputs.\n A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.\n OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.\n Inputs can be driven from either 3.3-V or 5-V devices. This feature allows the use of this device as a translator in a mixed 3.3-V/5-V system environment.\n This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.\n To ensure the high-impedance state during power up or power down, (OE) should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.\n \n

SN74LVC374A-Q1

OCTAL EDGE-TRIGGERED D-TYPE FLIP-FLOP WITH 3-STATE OUTPUTS