SN74LS624集成电路（IC）的可编程定时器振荡器规格书PDF中文资料

SN74LS624属于集成电路（IC）的可编程定时器振荡器。由德州仪器制造生产的SN74LS624可编程定时器和振荡器可以设置用来以指定频率提供定时脉冲的器件。

Separate Supply Voltage Pins for Isolation of

Frequency Control Inputs and Oscillators

from Output Circuitry

Highly Stable Operation over Specified

Temperature and/or Supply Voltage Ranges

description

‘These voltage-controlled oscillators (VCOs) are improved versions of the original VCO family: SNS4LS124, SN64LS324

thru SN54LS327, SN74L5124, and SNT4LS324 thru SN74LS327. These new devices feature improved voltage-to-

frequency linearity, range, and compensation. With the exception of the 'LS624 and 'LS628, all of thess devices feature

two independent VCOs in a single monolithic chip. The ‘L624, 'LS625, 'LS626, and 'LS628 have complementary

Z outputs. The output frequency for each VCO is established by a single external component (either a capacitor or

crystal) in combination with voltage-sensitive inputs used for frequency control and frequency range. Each device

has a voltage-sensitive input for frequency control; however, the 'LS624, LS628, and L562 devices also have one

for frequency range. (See Figures 1 thru 6).

The 'LS628 offers more precise temperature compensation than its 'LS624 counterpart, The 'LS624 features a 600 ohm

internal timing resistor. The 'LS628 requires a timing resistor to be connected externally across Rext pins. Temperature

compensation will be improved dur to the temperature coefficient of the external resistor.

Figure 3 and Figure 6 contain the necessary information to choose the proper capacitor value to obtain the desired

operating frequency.

A single 5-volt supply can be used: however, one set of supply voltage and ground pins (VCC and GND) is provided

for the enable, synchronization-gating, and output sections, and a separate set (SC VCC and OSC GND) is provided

for the oscillator and associated frequency-control circuits so that effective isolation can be accomplished in the system.

For operation of frequencies greater than 10 MH, it is recommended that two independent supplies be used. Disabling

either VCO of the 'LS625 and LS625 and 'LS627 can be achieved by removing the appropriate OSC VCC. An enable

input is provided on the 'LS624, LS626, 'LS628, and 'LS629. When the enable input is low, the output is enabled:

‘when the enable input is high, the internal oscillator is disabled, Y is high. and Z is low. Caution! Crosstalk may occur

in the dual devices ('LS625, 'LS626, 'LS627 and 'LS629) when both VCOs are operated simultaneously. To minimize

crosstalk, either of the following are recommended: (A) If frequencies are widsly separated, se a 10-uh inductor

between VCC pins. (B) If frequencies are closely spaced, use two separate VGC supplies or place two series diodes

between the Vc pins.

‘The pulse-synchronization-gating section ensures that the first output pulse is neither clipped nor extended. The duty

cycle of the square-wave output is fixed at approximately 50 percent.

‘The SN54LS624 thru SNS4LS629 are characterized for operation over the full military temperature range of — 55°C

to 125°C. The SN74LS624 thru SN74LS629 are characterized for operation from 0°C to 70°C.