SN74CB3Q16210DLR集成电路（IC）的信号开关多路复用器解码器规格书PDF中文资料

SN74CB3Q16210DLR属于集成电路（IC）的信号开关多路复用器解码器。由美国德州仪器公司制造生产的SN74CB3Q16210DLR信号开关，多路复用器，解码器逻辑型信号开关、多路复用器和编码器 IC 可用于对以数字格式表示数据的电信号进行路由和选择。这些器件与设计用于模拟信号的类似产品有所不同，它们保留的信息表示为两个电状态之一，而不是两个外部界限内的无穷变化量。

Member of the Texas Instruments

Widebus Family

High-Bandwidth Data Path

Up To 500 MHz†)

5-V Tolerant I/Os with Device Powered Up

or Powered Down

Low and Flat ON-State Resistance (ron)

Characteristics Over Operating Range

ron = 5 Ω Typical)

Rail-to-Rail Switching on Data I/O Ports

− 0-V to 5-V Switching With 3.3-V VCC

− 0-V to 3.3-V Switching With 2.5-V VCC

Bidirectional Data Flow, With Near-Zero

Propagation Delay

Low Input/Output Capacitance Minimizes

Loading and Signal Distortion

Cio(OFF) = 4 pF Typical)

Fast Switching Frequency

fOE = 20 MHz Max)

Data and Control Inputs Provide

Undershoot Clamp Diodes

Low Power Consumption

ICC = 1 mA Typical)

VCC Operating Range From 2.3 V to 3.6 V

Data I/Os Support 0 V to 5 V Signaling

Levels (0.8 V, 1.2 V, 1.5 V, 1.8 V, 2.5 V, 3.3 V,

5 V)

Control Inputs Can be Driven by TTL or

5-V/3.3-V CMOS Outputs

Ioff Supports Partial-Power-Down Mode

Operation

Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

ESD Performance Tested Per JESD 22

− 2000-V Human-Body Model

(A114-B, Class II)

− 1000-V Charged-Device Model (C101)

Supports Both Digital and Analog

Applications: PCI Interface, Differential

Signal Interface, Memory Interleaving, Bus

Isolation, Low-Distortion Signal Gating

description/ordering information

The SN74CB3Q16210 is a high-bandwidth FET bus switch utilizing a charge pump to elevate the gate voltage

of the pass transistor, providing a low and flat ON-state resistance (ron). The low and flat ON-state resistance

allows for minimal propagation delay and supports rail-to-rail switching on the data input/output (I/O) ports. The

device also features low data I/O capacitance to minimize capacitive loading and signal distortion on the data

bus. Specifically designed to support high-bandwidth applications, the SN74CB3Q16210 provides an optimized

interface solution ideally suited for broadband communications, networking, and data-intensive computing

systems.

The SN74CB3Q16210 is organized as two 10-bit bus switches with separate output-enable (1OE, 2OE) inputs.

It can be used as two 10-bit bus switches or as one 20-bit bus switch. When OE is low, the associated 10-bit

bus switch is ON and the A port is connected to the B port, allowing bidirectional data flow between ports. When

OE is high, the associated 10-bit bus switch is OFF, and a high-impedance state exists between the A and B

ports.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry prevents damaging

current backflow through the device when it is powered down. The device has isolation during power off.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.