SN74ALVCH162827GR集成电路（IC）的缓冲器驱动器接收器收发器规格书PDF中文资料

SN74ALVCH162827GR属于集成电路（IC）的缓冲器驱动器接收器收发器。由德州仪器制造生产的SN74ALVCH162827GR缓冲器，驱动器，接收器，收发器逻辑缓冲器、驱动器、接收器和收发器允许隔离对某个电路的逻辑信号的访问，以用于另一电路。缓冲器将其输入信号（不变或反相）传递到其输出，并可能用于清除弱信号或驱动负载。在布尔逻辑仿真器中，缓冲器主要用于增加传播延迟。逻辑接收器和收发器允许在数据总线之间进行隔离通信。

FEATURES

· Member of the Texas Instruments Widebus™

Family

· Output Ports Have Equivalent 26-W Series

Resistors, So No External Resistors Are

Required

· Bus Hold on Data Inputs Eliminates the Need

for External Pullup/Pulldown Resistors

· Latch-Up Performance Exceeds 250 mA Per

JESD 17

· ESD Protection Exceeds JESD 22

- 2000-V Human-Body Model (A114-A)

- 200-V Machine Model (A115-A)

- 1000-V Charged-Device Model (C101)

DESCRIPTION/ORDERING INFORMATION

This 20-bit noninverting buffer/driver is designed for

1.65-V to 3.6-V VCC operation.

The SN74ALVCH162827 is composed of two 10-bit

sections with separate output-enable signals. For

either 10-bit buffer section, the two output-enable

(1OE1 and 1OE2 or 2OE1 and 2OE2) inputs must

both be low for the corresponding Y outputs to be

active. If either output-enable input is high, the

outputs of that 10-bit buffer section are in the

high-impedance state.

The outputs, which are designed to sink up to 12 mA,

include equivalent 26-W resistors to reduce overshoot

and undershoot.

To ensure the high-impedance state during power up

or power down, OE should be tied to VCC through a

pullup resistor; the minimum value of the resistor is

determined by the current-sinking capability of the

driver.

Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors

with the bus-hold circuitry is not recommended.