SN74ABT18504PM.B中文资料德州仪器数据手册PDF规格书

Members of the Texas Instruments

SCOPE E Family of Testability Products

Members of the Texas Instruments

Widebus E Family

Compatible With the IEEE Standard

1149.1-1990 (JTAG) Test Access Port and

Boundary-Scan Architecture

UBT E (Universal Bus Transceiver)

Combines D-Type Latches and D-Type

Flip-Flops for Operation in Transparent,

Latched, or Clocked Mode

Two Boundary-Scan Cells per I/O for

Greater Flexibility

State-of-the-Art EPIC-IIB E BiCMOS Design

Significantly Reduces Power Dissipation

SCOPE E Instruction Set

– IEEE Standard 1149.1-1990 Required

Instructions, Optional INTEST, and

P1149.1A CLAMP and HIGHZ

– Parallel Signature Analysis at Inputs With

Masking Option

– Pseudo-Random Pattern Generation

From Outputs

– Sample Inputs/Toggle Outputs

– Binary Count From Outputs

– Device Identification

– Even-Parity Opcodes

Packaged in 64-Pin Plastic Thin Quad Flat

Pack Using 0.5-mm Center-to-Center

Spacings and 68-Pin Ceramic Quad Flat

Pack Using 25-mil Center-to-Center

Spacings

description

The SN54ABT18504 and SN74ABT18504 scan test devices with 20-bit universal bus transceivers are

members of the Texas Instruments SCOPEE testability IC family. This family of devices supports IEEE

Standard 1149.1-1990 boundary scan to facilitate testing of complex circuit board assemblies. Scan access to

the test circuitry is accomplished via the 4-wire test access port (TAP) interface.

In the normal mode, these devices are 20-bit universal bus transceivers that combine D-type latches and D-type

flip-flops to allow data flow in transparent, latched, or clocked modes. The test circuitry can be activated by the

TAP to take snapshot samples of the data appearing at the device pins or to perform a self test on the boundary

test cells. Activating the TAP in the normal mode does not affect the functional operation of the SCOPEE

universal bus transceivers.

Data flow in each direction is controlled by output-enable (OEAB and OEBA), latch-enable (LEAB and LEBA),

clock-enable (CLKENAB and CLKENBA), and clock (CLKAB and CLKBA) inputs. For A-to-B data flow, the

device operates in the transparent mode when LEAB is high. When LEAB is low, the A-bus data is latched while

CLKENAB is high and/or CLKAB is held at a static low or high logic level. Otherwise, if LEAB is low and

CLKENAB is low, A-bus data is stored on a low-to-high transition of CLKAB. When OEAB is low, the B outputs

are active. When OEAB is high, the B outputs are in the high-impedance state. B-to-A data flow is similar to

A-to-B data flow but uses the OEBA, LEBA, CLKENBA, and CLKBA inputs.

In the test mode, the normal operation of the SCOPEE universal bus transceivers is inhibited, and the test

circuitry is enabled to observe and control the I/O boundary of the device. When enabled, the test circuitry

performs boundary scan test operations according to the protocol described in IEEE Standard 1149.1-1990.