SN74ABT16601DLR.B中文资料德州仪器数据手册PDF规格书

Members of the Texas Instruments

WidebusE Family

State-of-the-Art EPIC-IIBE BiCMOS Design

Significantly Reduces Power Dissipation

UBT E (Universal Bus Transceiver)

Combines D-Type Latches and D-Type

Flip-Flops for Operation in Transparent,

Latched, Clocked, or Clock-Enabled Mode

Latch-Up Performance Exceeds 500 mA Per

JEDEC Standard JESD-17

Typical VOLP (Output Ground Bounce)

< 0.8 V at VCC = 5 V, TA = 25°C

Flow-Through Architecture Optimizes PCB

Layout

Package Options Include Plastic 300-mil

Shrink Small-Outline (DL) and Thin Shrink

Small-Outline (DGG) Packages and 380-mil

Fine-Pitch Ceramic Flat (WD) Package

Using 25-mil Center-to-Center Spacings

description

These 18-bit universal bus transceivers combine

D-type latches and D-type flip-flops to allow data

flow in transparent, latched, clocked, and

clock-enabled modes.

Data flow in each direction is controlled by

output-enable (OEAB and OEBA), latch-enable

(LEAB and LEBA), and clock (CLKAB and

CLKBA) inputs. The clock can be controlled by the

clock-enable (CLKENAB and CLKENBA) inputs.

For A-to-B data flow, the device operates in the

transparent mode when LEAB is high. When

LEAB is low, the A data is latched if CLKAB is held

at a high or low logic level. If LEAB is low, the

A data is stored in the latch/flip-flop on the

low-to-high transition of CLKAB. Output enable

OEAB is active low. When OEAB is low, the

outputs are active. When OEAB is high, the

outputs are in the high-impedance state.

Data flow for B to A is similar to that of A to B, but uses OEBA, LEBA, CLKBA, and CLKENBA.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

The SN54ABT16601 is characterized for operation over the full military temperature range of –55°C to 125°C.

The SN74ABT16601 is characterized for operation from –40°C to 85°C.