SN74ABT16543DL集成电路（IC）的缓冲器驱动器接收器收发器规格书PDF中文资料

SN74ABT16543DL属于集成电路（IC）的缓冲器驱动器接收器收发器。由美国德州仪器公司制造生产的SN74ABT16543DL缓冲器，驱动器，接收器，收发器逻辑缓冲器、驱动器、接收器和收发器允许隔离对某个电路的逻辑信号的访问，以用于另一电路。缓冲器将其输入信号（不变或反相）传递到其输出，并可能用于清除弱信号或驱动负载。在布尔逻辑仿真器中，缓冲器主要用于增加传播延迟。逻辑接收器和收发器允许在数据总线之间进行隔离通信。

Members of the Texas Instruments

WidebusE Family

State-of-the-Art EPIC-IIBE BiCMOS Design

Significantly Reduces Power Dissipation

Latch-Up Performance Exceeds 500 mA Per

JEDEC Standard JESD-17

Typical VOLP (Output Ground Bounce) < 1 V

at VCC = 5 V, TA = 25°C

Distributed VCC and GND Pin Configuration

Minimizes High-Speed Switching Noise

Flow-Through Architecture Optimizes PCB

Layout

High-Drive Outputs (–32-mA IOH, 64-mA IOL)

Package Options Include Plastic 300-mil

Shrink Small-Outline (DL) and Thin Shrink

Small-Outline (DGG) Packages and 380-mil

Fine-Pitch Ceramic Flat (WD) Package

Using 25-mil Center-to-Center Spacings

description

The ’ABT16543 16-bit registered transceivers

contain two sets of D-type latches for temporary

storage of data flowing in either direction. The

’ABT16543 can be used as two 8-bit transceivers

or one 16-bit transceiver. Separate latch-enable

(LEAB or LEBA) and output-enable (OEAB or

OEBA) inputs are provided for each register to

permit independent control in either direction of

data flow.

The A-to-B enable (CEAB) input must be low to

enter data from A or to output data from B. If CEAB

is low and LEAB is low, the A-to-B latches are

transparent; a subsequent low-to-high transition

of LEAB puts the A latches in the storage mode.

With CEAB and OEAB both low, the 3-state

B outputs are active and reflect the data present

at the output of the A latches. Data flow from B to

A is similar but requires using the CEBA, LEBA,

and OEBA inputs.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

The SN54ABT16543 is characterized for operation over the full military temperature range of –55°C to 125°C.

The SN74ABT16543 is characterized for operation from –40°C to 85°C.