SN65MLVD206

半双工 M-LVDS 收发器; • Low-Voltage Differential 30- Line Drivers and Receivers for Signaling Rates\n Up to 200 Mbps\n• Type-1 Receivers Incorporate 25 mV of Hysteresis\n• Type-2 Receivers Provide an Offset (100 mV) Threshold to Detect Open-Circuit and Idle-Bus Conditions\n• Meets or Exceeds the M-LVDS Standard TIA/EIA-899 for Multipoint Data Interchange\n• Controlled Driver Output Voltage Transition Times for Improved Signal Quality\n• –1 V to 3.4 V Common-Mode Voltage Range Allows Data Transfer With 2V of Ground Noise\n• Bus Pins High Impedance When Disabled or VCC ≤ 1.5 V\n• 100-Mbps Devices Available (SN65MLVD200A, 202A, 204A, 205A)\n• M-LVDS Bus Power Up/Down Glitch Free\n• APPLICATIONS \n - Low-Power High-Speed Short-Reach Alternative to TIA/EIA-485\n• Backplane or Cabled Multipoint Data and Clock Transmission\n• Cellular Base Stations\n• Central-Office Switches\n• Network Switches and Routers\n \n The signaling rate of a line, is the number of voltage transitions that are made per second expressed in the units bps (bits per second).;

The SN65MLVD201, 203, 206, and 207 are multipoint-low-voltage differential (M-LVDS) line drivers and receivers, which are optimized to operate at signaling rates up to 200 Mbps. All parts comply with the multipoint low-voltage differential signaling (M-LVDS) standard TIA/EIA-899. These circuits are similar to their TIA/EIA-644 standard compliant LVDS counterparts, with added features to address multipoint applications. The driver output has been designed to support multipoint buses presenting loads as low as 30 , and incorporates controlled transition times to allow for stubs off of the backbone transmission line.\n These devices have Type-1 and Type-2 receivers that detect the bus state with as little as 50 mV of differential input voltage over a common-mode voltage range of –1 V to 3.4 V. The Type-1 receivers exhibit 25 mV of differential input voltage hysteresis to prevent output oscillations with slowly changing signals or loss of input. Type-2 receivers include an offset threshold to provide a known output state under open-circuit, idle-bus, and other faults conditions. The devices are characterized for operation from –40°C to 85°C.\n \n

SN65MLVD206

MULTIPOINT-LVDS LINE DRIVER AND RECEIVER

SN65MLVD206

MULTIPOINT-LVDS LINE DRIVER AND RECEIVER

SN65MLVD206B

高噪声抗扰度 200Mbps M-LVDS 收发器; • 与 M-LVDS 标准 TIA/EIA-899 兼容，可进行多点数据交换\n• 低电压差分 30Ω 至 55Ω 线路驱动器和接收器，信号传输速率\n 高达 200Mbps，时钟频率高达 100MHz \n• 2 类接收器的偏移阈值可检测开路和空闲总线状态\n \n• 总线 I/O 保护 \n• ±8kV HBM\n• ±8kV IEC 61000-4-2 接触放电\n \n• 驱动器输出电压转换时间可控，可改善信号质量\n• –1V 至 3.4V 共模电压范围，可实现在 2V 接地噪声下进行数据传输\n• 总线引脚在禁用或 VCC ≤ 1.5V 时具有高阻抗 \n• 提供 100Mbps 器件 (SN65MLVD204B)\n• SN65MLVD206 的改进备选器件 \n \n线路的信号传输速率是指每秒钟的电压转换次数，单位为 bps（每秒比特数）;

SN65MLVD206B 器件是一款多点低电压差分信号 (M-LVDS) 线路驱动器和接收器，经优化，能够以最高 200Mbps 的信号传输速率运行。该器件具有稳健耐用的 3.3V 驱动器和接收器，并且采用标准 SOIC 封装，适用于严苛的工业 应用。总线引脚可耐受 ESD 事件，具有针对人体模型和 IEC 接触放电规范的高级保护。\n\n该器件包含一个差分驱动器和一个差分接收器（收发器），由 3.3V 电源供电。该收发器经过优化，能够以最高 200Mbps 的信号传输速率运行。\n\nSN65MLVD206B 较同类器件具有增强特性。这些 增强特性 包括驱动器输出端转换率可控，有助于尽量减少无端桩线的反射，从而提高信号完整性。沿用了相同尺寸，可轻松替换，有助于提升系统性能。这些器件的额定工作温度范围为 -40°C 至 85°C。\n\nSN65MLVD206B M-LVDS 接收器是 TI 广泛的 M-LVDS 产品系列器件。

SN65MLVD206B

Multipoint-LVDS Line Drivers and Receivers (Transceivers) With IEC ESD Protection

SN65MLVD206BD

Multipoint-LVDS Line Drivers and Receivers (Transceivers) With IEC ESD Protection

SN65MLVD206BDR

Multipoint-LVDS Line Drivers and Receivers (Transceivers) With IEC ESD Protection

SN65MLVD206D

MULTIPOINT-LVDS LINE DRIVER AND RECEIVER

SN65MLVD206D

MULTIPOINT-LVDS LINE DRIVER AND RECEIVER

SN65MLVD206D

MULTIPOINT-LVDS LINE DRIVER AND RECEIVER