SN65LVDM31DG4集成电路（IC）的驱动器接收器收发器规格书PDF中文资料

SN65LVDM31DG4属于集成电路（IC）的驱动器接收器收发器。由美国德州仪器公司制造生产的SN65LVDM31DG4驱动器，接收器，收发器该系列产品的主要功能是提供必需的硬件资源，以通过延长电缆或印制线进行通信。确切的功能会因所采用的通信协议而异，可能包括诸如瞬态抑制之类的功能，这些功能对于通信用途可能并非绝对必要，但对于可能的使用环境却是明智之选。

FEATURES

· Designed for Signaling Rates

NOTE: The signaling rate is the number of voltage transitions that

can be made per second.

Up to 150 Mbps

· Low-Voltage Differential Signaling With

Typical Output Voltage of 700 mV and a 100-W

Load

· Propagation Delay Time of 2.3 ns, Typical

· Single 3.3-V Supply Operation

· One Driver's Power Dissipation at 75 MHz,

50 mW, Typical

· High-Impedance Outputs When Disabled or

With VCC < 1.5 V

· Bus-Pin ESD Protection Exceeds 12 kV

· Low-Voltage CMOS (LVCMOS) Logic Input

Levels Are 5-V Tolerant

DESCRIPTION

The SN65LVDM31 incorporates four differential line

drivers that implement the electrical characteristics of

low-voltage differential signaling. This product offers a

low-power alternative to 5-V PECL drivers with similar

signal levels. Any of the four current-mode drivers will

deliver a minimum differential output voltage

magnitude of 540 mV into a 100-W load when

enabled by either an active-low or active-high enable

input.

The intended application of this device and signaling

technique is for both point-to-point and multiplexed

baseband data transmission over controlled

impedance media of approximately 100 W. The

transmission media may be printed-circuit board

traces, backplanes, or cables. The ultimate rate and

distance of data transfer is dependent upon the

attenuation characteristics of the media and the noise

coupling to the environment.

The SN65LVDM31 is characterized for operation from

–40°C to 85°C.