SN65LVDM050-Q1中文资料德州仪器数据手册PDF规格书

Qualified for Automotive Applications

ESD Protection Exceeds 2000 V Per

MIL-STD-883, Method 3015; Exceeds 200 V

Using Machine Model (C = 200 pF, R = 0)

Low-Voltage Differential 50-Ω Line Drivers

and Receivers

Signaling Rates up to 500 Mbps

Bus-Terminal ESD Exceeds 12 kV

Operates From a Single 3.3 V Supply

Low-Voltage Differential Signaling With

Typical Output Voltages of 340 mV With a

50-Ω Load

Valid Output With as Little as 50-mV Input

Voltage Difference

Propagation Delay Times

− Driver: 1.7 ns Typ

− Receiver: 3.7 ns Typ

Power Dissipation at 200 MHz

− Driver: 50 mW Typical

− Receiver: 60 mW Typical

LVTTL Input Levels Are 5 V Tolerant

Driver Is High Impedance When Disabled or

With VCC < 1.5 V

Receiver Has Open-Circuit Fail Safe

description

The SN65LVDM050, and SN65LVDM051 are differential line drivers and receivers that use low-voltage

differential signaling (LVDS) to achieve signaling rates as high as 500 Mbps (per TIA/EIA-644 definition). These

circuits are similar to TIA/EIA-644 standard compliant devices (SN65LVDS) counterparts, except that the output

current of the drivers is doubled. This modification provides a minimum differential output voltage magnitude

of 247 mV across a 50-Ω load simulating two transmission lines in parallel. This allows having data buses with

more than one driver or with two line termination resistors. The receivers detect a voltage difference of 50 mV

with up to 1 V of ground potential difference between a transmitter and receiver.

The intended application of these devices and signaling techniques is point-to-point and multipoint, baseband

data transmission over a controlled impedance media of approximately 100 Ω of characteristic impedance. The

transmission media may be printed-circuit board traces, backplanes, or cables.