SAA8116中文资料飞利浦数据手册PDF规格书

GENERAL DESCRIPTION

The SAA8116 is a highly integrated third generation USB PC-camera ICs. It is the successor to the SAA8112HL and SAA8115HL. It processes the digitized sensor data and converts it to a high quality, compressed YUV signal. Together with the audio signal, this video signal is then properly formatted in USB packets.

FEATURES

• Embedded microcontroller (80C51 core based) for control loops Auto Optical Black (AOB), Auto White Balance (AWB), Auto Exposure (AE) and USB interface control

• Compliant for VGA CCD and VGA CMOS sensors (RGB Bayer)

• USB 1.1 compliant bus-powered USB device with integrated power management and POR circuit

• RGB processing

• Optical black processing

• Defect pixel concealment

• Programmable colour matrix

• RGB to YUV transform

• Programmable gamma correction (including knee)

• Programmable edge enhancement

• Video formatter with SIF/QSIF downscaler

• Compression engine

• Flexible Measurement Engine (ME) with up to eight measurements per frame

• Internal Pulse Pattern Generator (PPG) for wide range of VGA CCDs (Sony, Sharp and Panasonic) and frame rate selection

• Programmable H and V timing for the support of CMOS sensors

• Programmable output pulse for switched mode power supply of the sensor

• 3-wire interface to control an external pre-processor IC, such as the TDA8787A: Correlated Double Sampling (CDS), Automatic Gain Control (AGC) and 10-bit ADC

• Analog microphone/audio input to USB: Low DropOut (LDO) supply filter, microphone supply, low noise amplifier, programmable amplifier, PLL and ADC

• Integrated analog USB driver (ATX)

• Integrated main oscillator, including a clock PLL, which derives 48 MHz main system clock from a 12 or 48 MHz fundamental crystal.

APPLICATION

• USB PC-camera (video and audio).