PLM9502工业自动化与控制的监控器-继电器输出规格书PDF中文资料

PLM9502属于工业自动化与控制的监控器-继电器输出。由力特公司制造生产的PLM9502监控器 - 继电器输出继电器输出监控器检测工业继电器的异常输出，并触发逻辑输出或触头组。常见的检测类型包括：AC 和 DC 电流或电压、电压不对称、接地故障、温度监控、缺相，以及相位序列或不平衡。这些器件可根据跳闸范围、延迟时间、供电电压、安装类型和开关电路进行选择。

描述 Description

The PLM Series is a 3-phase voltage monitor that continuously

monitors each of the three phases. Monitors both delta and

wye systems and no connection to neutral is required. The

microcontroller circuit design protects against undervoltage,

voltage unbalance, phase loss and phase reversal. Protection is

assured when regenerated voltages are present.

Operation

The output relay is energized and the LED glows green

when all voltages are acceptable and the phase sequence is

correct. Under and unbalanced voltages must be sensed for a

continuous trip delay period before the relay de-energizes. Reset

is automatic upon correction of the fault condition. The output

relay will not energize if a fault condition is sensed as power is

applied. The LED flashes red during the trip delay, then glows

red when the output de-energizes. The LED flashes green/red if

phase reversal is sensed.

Field Adjustment

Set voltage adjustment knob at the desired operating line

voltage for the equipment. This adjustment automatically sets

the undervoltage trip point. Apply power. If the PLM fails to

energize, (LED glows red) check wiring of all three phases,

voltage, and phase sequence. If phase sequence is incorrect,

the LED flashes green/red. To correct this, swap any two

line voltage connections at the mounting socket. No further

adjustment should be required.

FEATURES BENEFITS

Quick octal 8-pin

mounting

Small footprint with universal mounting: ideal

replacement for hundreds of competitive

part numbers.

Proprietary

microcontroller

based circuitry

Constant monitoring of single-phase, low voltage,

high voltage, voltage unbalance, phase reversal.

LED diagnostics Quick visual indicator for trip versus

normal operation.

Isolated, 10A, SPDT

output contacts Allows control of loads for AC voltages

Adjustable nominal

voltage set point

Allows setting for specific application

voltage to optimize protection

Simple 3-wire connection

for delta or wye systems Allows flexibility across wide range of systems

ASME A17.1 Rule 210.6 Complies with safety codes for elevators,

escalators, moving walkways

NEMA MG1 14:30, 14:35 Complies with safety codes for motors

and generators

IEEE C62.41-1991 Level B Complies with safety codes for surge and

voltage protection