PIC18LF46K80中文资料微芯科技数据手册PDF规格书

DEVICE OVERVIEW

This document contains device-specific information for the following devices:

• PIC18F25K80 • PIC18LF25K80

• PIC18F26K80 • PIC18LF26K80

• PIC18F45K80 • PIC18LF45K80

• PIC18F46K80 • PIC18LF46K80

• PIC18F65K80 • PIC18LF65K80

• PIC18F66K80 • PIC18LF66K80

This family combines the traditional advantages of all PIC18 microcontrollers – namely, high computational performance and a rich feature set – with an extremely competitive price point. These features make the PIC18F66K80 family a logical choice for many high-performance applications where price is a primary consideration.

Power-Managed Modes:

• Run: CPU on, Peripherals on

• Idle: CPU off, Peripherals on

• Sleep: CPU off, Peripherals off

• Two-Speed Oscillator Start-up

• Fail-Safe Clock Monitor (FSCM)

• Power-Saving Peripheral Module Disable (PMD)

• Ultra Low-Power Wake-up

• Fast Wake-up, 1 s, Typical

• Low-Power WDT, 300 nA, Typical

• Run mode Currents Down to Very Low 3.8 A, Typical

• Idle mode Currents Down to Very Low 880 nA, Typical

• Sleep mode Current Down to Very Low 13 nA, Typical

ECAN Bus Module Features:

• Conforms to CAN 2.0B Active Specification

• Three Operating modes:

- Legacy mode (full backward compatibility with existing PIC18CXX8/FXX8 CAN modules)

- Enhanced mode

- FIFO mode or programmable TX/RX buffers

• Message Bit Rates up to 1 Mbps

• DeviceNet™ Data Byte Filter Support

• Six Programmable Receive/Transmit Buffers

• Three Dedicated Transmit Buffers with Prioritization

• Two Dedicated Receive Buffers

• 16 Full, 29-Bit Acceptance Filters with Dynamic Association

• Three Full, 29-Bit Acceptance Masks

• Automatic Remote Frame Handling

• Advanced Error Management Features

Special Microcontroller Features:

• Operating Voltage Range: 1.8V to 5.5V

• On-Chip 3.3V Regulator

• Operating Speed up to 64 MHz

• Up to 64 Kbytes On-Chip Flash Program Memory:

- 10,000 erase/write cycle, typical

- 20 years minimum retention, typical

• 1,024 Bytes of Data EEPROM:

- 100,000 Erase/write cycle data EEPROM memory, typical

• 3.6 Kbytes of General Purpose Registers (SRAM)

• Three Internal Oscillators: LF-INTOSC (31 KHz), MF-INTOSC (500 kHz) and HF-INTOSC (16 MHz)

• Self-Programmable under Software Control

• Priority Levels for Interrupts

• 8 x 8 Single-Cycle Hardware Multiplier

• Extended Watchdog Timer (WDT):

- Programmable period from 4 ms to 4,194s

• In-Circuit Serial Programming™ (ICSP™) via Two Pins

• In-Circuit Debug via Two Pins

• Programmable BOR

• Programmable LVD