PIC18F6625中文资料微芯科技数据手册PDF规格书

Power Managed Modes:

• Run: CPU on, peripherals on

• Idle: CPU off, peripherals on

• Sleep: CPU off, peripherals off

• Idle mode currents down to 5.8 µA typical

• Sleep current down to 0.1 µA typical

• Timer1 Oscillator: 1.8 µA, 32 kHz, 2V

• Watchdog Timer: 2.1 µA

• Two-Speed Oscillator Start-up

Flexible Oscillator Structure:

• Four Crystal modes, up to 40 MHz

• 4X Phase Lock Loop (available for crystal and

internal oscillators)

• Two External RC modes, up to 4 MHz

• Two External Clock modes, up to 40 MHz

• Internal oscillator block:

- 8 user selectable frequencies, from 31 kHz to 8 MHz

- Provides a complete range of clock speeds from

31 kHz to 32 MHz when used with PLL

- User tunable to compensate for frequency drift

• Secondary oscillator using Timer1 @ 32 kHz

• Fail-Safe Clock Monitor:

- Allows for safe shutdown if peripheral clock stops

External Memory Interface

(PIC18F8625/8721 only):

• Address capability of up to 2 Mbytes

• 8-bit or 16-bit interface

Peripheral Highlights:

• High current sink/source 25 mA/25 mA

• Four programmable external interrupts

• Four input change interrupts

• Two Capture/Compare/PWM (CCP) modules

• Three Enhanced Capture/Compare/PWM (ECCP)

modules:

- One, two or four PWM outputs

- Selectable polarity

- Programmable dead-time

- Auto-Shutdown and Auto-Restart

• Two Master Synchronous Serial Port (MSSP)

modules supporting 3-wire SPI™ (all 4 modes) and

I2C™ Master and Slave modes

• Two Enhanced Addressable USART modules:

- Supports RS-485, RS-232 and LIN 1.2

- RS-232 operation using internal oscillator block

(no external crystal required)

- Auto-wake-up on Start bit

- Auto-baud detect

• 10-bit, up to 16-channel Analog-to-Digital Converter

module (A/D)

- Auto-acquisition capability

- Conversion available during Sleep

• Dual analog comparators with input multiplexing

Special Microcontroller Features:

• C compiler optimized architecture:

- Optional extended instruction set designed to

optimize re-entrant code

• 100,000 erase/write cycle Enhanced Flash program

memory typical

• 1,000,000 erase/write cycle Data EEPROM memory

typical

• Flash/Data EEPROM Retention: 100 years typical

• Self-programmable under software control

• Priority levels for interrupts

• 8 X 8 Single Cycle Hardware Multiplier

• Extended Watchdog Timer (WDT):

- Programmable period from 4 ms to 131s

• Single-supply 5V In-Circuit Serial Programming™

(ICSP™) via two pins

• In-Circuit Debug (ICD) via two pins

• Wide operating voltage range: 2.0V to 5.5V