PIC18C801E/PT中文资料微芯科技数据手册PDF规格书

DEVICE OVERVIEW

This document contains device specific information for the following two devices:

1. PIC18C601

2. PIC18C801

The PIC18C601 is available in 64-pin TQFP and 68-pin PLCC packages. The PIC18C801 is available in 80-pin TQFP and 84-pin PLCC packages.

An overview of features is shown in Table 1-1.

Device block diagrams are provided in Figure 1-1 for the 64/68-pin configuration, and Figure 1-2 for the 80/84-pin configuration. The pinouts for both packages are listed in Table 1-2.

High Performance RISC CPU:

• C compiler optimized architecture instruction set

• Linear program memory addressing up to 2 Mbytes

• Linear data memory addressing to 4 Kbytes

• Up to 160 ns instruction cycle:

- DC - 25 MHz clock input

- 4 MHz - 6 MHz clock input with PLL active

• 16-bit wide instructions, 8-bit wide data path

• Priority levels for interrupts

• 8 x 8 Single Cycle Hardware Multiplier

Peripheral Features:

• High current sink/source 25 mA/25 mA

• Up to 47 I/O pins with individual direction control

• Three external interrupt pins

• Timer0 module: 8-bit/16-bit timer/counter with 8-bit programmable prescaler

• Timer1 module: 16-bit timer/counter (time-base for CCP)

• Timer2 module: 8-bit timer/counter with 8-bit period register

• Timer3 module: 16-bit timer/counter

• Secondary oscillator clock option - Timer1/Timer3

• Two Capture/Compare/PWM (CCP) modules CCP pins can be configured as:

- Capture input: 16-bit, max. resolution 10 ns

- Compare is 16-bit, max. resolution 160 ns (TCY)

- PWM output: PWM resolution is 1- to 10-bit Max. PWM freq. @:

8-bit resolution = 99 kHz

10-bit resolution = 24.4 kHz

• Master Synchronous Serial Port (MSSP) with two modes of operation:

- 3-wire SPI™ (Supports all 4 SPI modes)

- I2C™ Master and Slave mode

• Addressable USART module: Supports Interrupt on Address bit

Advanced Analog Features:

• 10-bit Analog-to-Digital Converter module (A/D) with:

- Fast sampling rate

- Conversion available during SLEEP

- DNL = ±1 LSb, INL = ±1 LSb

- Up to 12 channels available

• Programmable Low Voltage Detection (LVD) module

- Supports interrupt on Low Voltage Detection

Special Microcontroller Features:

• Power-on Reset (POR), Power-up Timer (PWRT), and Oscillator Start-up Timer (OST)

• Watchdog Timer (WDT) with its own on-chip RC oscillator

• On-chip Boot RAM for boot loader application

• 8-bit or 16-bit external memory interface modes

• Up to two software programmable chip select signals (CS1 and CS2)

• One programmable chip I/O select signal (CSIO) for memory mapped I/O expansion

• Power saving SLEEP mode

• Different oscillator options, including:

- 4X Phase Lock Loop (of primary oscillator)

- Secondary Oscillator (32 kHz) clock input

CMOS Technology:

• Low power, high speed CMOS technology

• Fully static design

• Wide operating voltage range (2.0V to 5.5V)

• Industrial and Extended temperature ranges

• Low power consumption