DEVICE OVERVIEW

This document contains device specific information for the operation of the PIC16F84A device. Additional information may be found in the PICmicro™ Mid Range Reference Manual, (DS33023), which may be downloaded from the Microchip website. The Refer ence Manual should be considered a complementary document to this data sheet, and is highly recom mended reading for a better understanding of the device architecture and operation of the peripheral modules.

High Performance RISC CPU Features:

• Only 35 single word instructions to learn

• All instructions single-cycle except for program branches which are two-cycle

• Operating speed: DC - 20 MHz clock input DC - 200 ns instruction cycle

• 1024 words of program memory

• 68 bytes of Data RAM

• 64 bytes of Data EEPROM

• 14-bit wide instruction words

• 8-bit wide data bytes

• 15 Special Function Hardware registers

• Eight-level deep hardware stack

• Direct, indirect and relative addressing modes

• Four interrupt sources:

- External RB0/INT pin

- TMR0 timer overflow

- PORTB interrupt-on-change

- Data EEPROM write complete

Peripheral Features:

• 13 I/O pins with individual direction control

• High current sink/source for direct LED drive

- 25 mA sink max. per pin

- 25 mA source max. per pin

• TMR0: 8-bit timer/counter with 8-bit programmable prescaler

Special Microcontroller Features:

• 10,000 erase/write cycles Enhanced FLASH Program memory typical

• 10,000,000 typical erase/write cycles EEPROM Data memory typical

• EEPROM Data Retention > 40 years

• In-Circuit Serial Programming™ (ICSP™) - via two pins

• Power-on Reset (POR), Power-up Timer (PWRT), Oscillator Start-up Timer (OST)

• Watchdog Timer (WDT) with its own On-Chip RC Oscillator for reliable operation

• Code protection

• Power saving SLEEP mode

• Selectable oscillator options

PIC16LF84A-04/SS属于集成电路（IC） > 微控制器。微芯科技股份有限公司制造生产的PIC16LF84A-04/SS微控制器微控制器产品是相对复杂的用户可编程数字逻辑器件。这些产品与视为微控制器的器件密切相关，两者之间的区别主要体现在制造商选择的用词。不过按照传统，微控制器集成了工作存储器，也更可能包含混合信号外设，并且往往与更简单的软件范例结合使用，旨在重复执行一系列预定义的任务。