PCA9704PWSLASHQ900中文资料恩XP数据手册PDF规格书

General description

The PCA9704 is a low power 18 V tolerant SPI General Purpose Input (GPI) shift register

designed to monitor the status of switch inputs. It generates an interrupt when one or

more of the switch inputs change state but allows selected inputs to not generate

interrupts using the interrupt masking feature. The input level is recognized as a HIGH

when it is greater than 0.8  VDD and as a LOW when it is less than 0.55  VDD (minimum

LOW threshold of 2.5 V at 5 V node). The PCA9704 can monitor up to 8 switch inputs.

The falling edge of the CS pin samples the input port status and clears the interrupt. When

CS is LOW, the rising edge of the SCLK loads the shift register and shifts the value out of

the shift register. The serial input is sampled on the falling edge of SCLK. The contents of

the shift register are loaded into the interrupt mask register of the device on the rising

edge of CS.

Each of the input ports has a 18 V breakdown ESD protection circuit, which dumps the

ESD/overvoltage current to ground. When used with a series resistor (minimum 100 k),

the input can connect to a 12 V battery and support double battery, reverse battery, 27 V

jump start and 40 V load dump conditions in automotive applications. Higher voltages can

be tolerated on the inputs depending on the series resistor used to limit the input current.

The INT_EN pin is used to both enable the GPI pins and to enable the INT output pin to

minimize battery drain in cyclically supplied pull-up or pull-down applications. The SDIN

pull-down prevents floating nodes when the device is used in daisy-chain applications.

With both the high breakdown voltage and high ESD, this device is useful for both

automotive (AEC-Q100 compliance available) and mobile applications.

Features and benefits

 8 general purpose input ports

 18 V tolerant input ports with 100 k external series resistor

 Input LOW threshold 0.55  VDD with minimum of 2.5 V at VDD = 4.5 V

 Open-drain interrupt output

 Interrupt enable pin (INT_EN) disables GPI pins and interrupt output

 Interrupt-masking feature allows no interrupt generation from selected inputs

 VDD range: 4.5 V to 5.5 V

 IDD is very low 2.5 A maximum

 SPI serial interface with speeds up to 5 MHz

 SPI supports daisy-chain connection for large switch numbers

 AEC-Q100 compliance available