PCA9555AHF中文资料Low-voltage 16-bit I2C-bus I/O port with interrupt and weak pull-up数据手册恩XP规格书

描述 Description

The PCA9555A is a low-voltage 16-bit General Purpose Input/Output (GPIO) expanderwith interrupt and weak pull-up resistors for I²C-bus/SMBus applications. NXP I/Oexpanders provide a simple solution when additional I/Os are needed while keepinginterconnections to a minimum, for example, in ACPI power switches, sensors, pushbuttons, LEDs, fan control, etc.
In addition to providing a flexible set of GPIOs, the wide VDD range of 1.65 V to 5.5 Vallows the PCA9555A to interface with next-generation microprocessors andmicrocontrollers where supply levels are dropping down to conserve power.
The PCA9555A contains the PCA9555 register set of four pairs of 8-bit Configuration,Input, Output, and Polarity Inversion registers.
The PCA9555A is a pin-to-pin replacement to the PCA9555 and other industry-standarddevices. A more fully featured device, the PCAL9555A, is available with Agile I/Ofeatures. See the respective data sheet for more details.
The PCA9555A open-drain interrupt (INT) output is activated when any input state differsfrom its corresponding Input Port register state and is used to indicate to the systemmaster that an input state has changed.
INT can be connected to the interrupt input of a microcontroller. By sending an interruptsignal on this line, the remote I/O can inform the microcontroller if there is incoming dataon its ports without having to communicate via the I²C-bus. Thus, the PCA9555A canremain a simple slave device.
The device outputs have 25 mA sink capabilities for directly driving LEDs while consuminglow device current.
The power-on reset sets the registers to their default values and initializes the device statemachine.
All input/output pins have weak pull-up resistors connected to them to eliminate externalcomponents.
Three hardware pins (A0, A1, A2) select the fixed I²C-bus address and allow up to eightdevices to share the same I²C-bus/SMBus.

特性 Features

I²C-bus to parallel port expander
Operating power supply voltage range of 1.65 V to 5.5 V
Low standby current consumption:1.5 μA (typical at 5 V VDD)
1.0 μA (typical at 3.3 V VDD)
Schmitt-trigger action allows slow input transition and better switching noise immunityat the SCL and SDA inputs:Vhys = 0.10 x VDD (typical)
5 V tolerant I/Os
Open-drain active LOW interrupt output (INT)
400 kHz Fast-mode I²C-bus
Internal power-on reset
Power-up with all channels configured as inputs with weak pull-up resistors
No glitch on power-up
Latched outputs with 25 mA drive maximum capability for directly driving LEDs
Latch-up performance exceeds 100 mA per JESD78, Class II
ESD protection exceeds JESD22:2000 V Human Body Model (A114-A)
1000 V Charged-Device Model (C101)
Packages offered: TSSOP24, HWQFN24