PCA9535DBQR集成电路（IC）的I/O扩展器规格书PDF中文资料

PCA9535DBQR属于集成电路（IC）的I/O扩展器。由德州仪器制造生产的PCA9535DBQRI/O 扩展器该系列器件可与微控制器、微处理器或类似器件结合使用，目的是增加可用于连接外设的信号连接数量。典型的工作概念涉及使用串行通信，只需主机设备上的几根 I/O 线，即可读/写扩展器设备上的许多输入/输出引脚的状态。该技术的通信速度不佳，但连通性较高，最适合快速响应不是很关键的应用，例如许多人机界面应用。

1 Features

• Low standby-current consumption of 1 μA Max

• I2C to Parallel port expander

• Open-drain active-low interrupt output

• 5-V Tolerant I/O ports

• Compatible with most microcontrollers

• 400-kHz Fast I2C Bus

• Address by three hardware address pins for use of

up to eight devices

• Polarity inversion register

• Latched outputs with high-current drive capability

for directly driving LEDs

• Latch-up performance exceeds 100 mA Per

JESD 78, class II

• ESD Protection exceeds JESD 22

– 2000-V Human-body model (A114-A)

– 1000-V Charged-device model (C101)

2 Description

This 16-bit I/O expander for the two-line bidirectional

bus (I2C) is designed for 2.3-V to 5.5-V VCC operation.

It provides general-purpose remote I/O expansion for

most microcontroller families via the I2C interface

[serial clock (SCL), serial data (SDA)].

The PCA9535 consists of two 8-bit Configuration

(input or output selection), Input Port, Output Port,

and Polarity Inversion (active-high or active-low

operation) registers. At power on, the I/Os are

configured as inputs. The system master can enable

the I/Os as either inputs or outputs by writing to the

I/O configuration bits. The data for each input or

output is kept in the corresponding Input or Output

Port register. The polarity of the Input Port register

can be inverted with the Polarity Inversion register. All

registers can be read by the system master.

The system master can reset the PCA9535 in the

event of a timeout or other improper operation by

utilizing the power-on reset feature, which puts the

registers in their default state and initializes the I2C/

SMBus state machine.

The PCA9535 open-drain interrupt (INT) output is

activated when any input state differs from its

corresponding Input Port register state and is used to

indicate to the system master that an input state has

changed.