8-bit I2C and SMBus I/O port with interrupt, 2-kbit EEPROM and 6 address pins

DESCRIPTION The PCA9501 is an 8-bit I/O expander with an on-board 2-kbit EEPROM. The I/O expandable eight quasi bidirectional data pins can be independently assigned as inputs or outputs to monitor board level status or activate indicator devices such as LEDs. The system master writes to the I/O

文件：146.48 Kbytes 页数：22 Pages

PHI

PHI

8-bit I2C-bus and SMBus I/O port with interrupt, 2-kbit EEPROM and 6 address pins

General description The PCA9501 is an 8-bit I/O expander with an on-board 2-kbit EEPROM. The I/O expandable eight quasi-bidirectional data pins can be independently assigned as inputs or outputs to monitor board level status or activate indicator devices such as LEDs. The system master writes to

文件：178.12 Kbytes 页数：28 Pages

恩XP

8-bit I2C-bus and SMBus I/O port with interrupt, 2-kbit EEPROM and 6 address pins

The PCA9501 is an 8-bit I/O expander with an on-board 2-kbit EEPROM.\nThe I/O expandable eight quasi-bidirectional data pins can be independently assigned as inputs or outputs to monitor board level status or activate indicator devices such as LEDs. The system master writes to the I/O configuration 8 general purpose input/output expander/collector\nReplacement for PCF8574 with integrated 2-kbit EEPROM\nInternal 256 x 8 EEPROM\nSelf timed write cycle (5 ms typical)\n16 byte page write operation\nI²C-bus and SMBus interface logic\nInternal power-on reset\nNoise filter on SCL/SDA inputs\nActive L;

恩XP

12-Bit, Voltage Output D/A Converter

DESCRIPTION… The SP9501 is a low power 12-Bit Digital-to-Analog Converter. It features ±4.5V output swings when using ±5 volt supplies. The converter uses a standard 3–wire serial interface compatible with SPI™, QSPI™ and Microwire™. The output settling-time is specified at 4µs. The SP9501 is ava

文件：159.73 Kbytes 页数：9 Pages

SIPEX

12-Bit, Voltage Output D/A Converter

DESCRIPTION… The SP9501 is a low power 12-Bit Digital-to-Analog Converter. It features ±4.5V output swings when using ±5 volt supplies. The converter uses a standard 3–wire serial interface compatible with SPI™, QSPI™ and Microwire™. The output settling-time is specified at 4µs. The SP9501 is ava

文件：159.73 Kbytes 页数：9 Pages

SIPEX

531/1063 Mbaud Fibre Channel Transmitter and Receiver

TriQuint’s Fibre Channel transmitter (TQ9501) and receiver (TQ9502) are part of the FC531/FC1063 (Fibre Channel 531 and 1063 Megabaud) chip set. In addition to the transmitter and receiver, TriQuint offers the ENcoder/DECoder (TQ9303 ENDEC). The TQ9501, TQ9502, TQ9303 and a gigabit fiber optic mod

文件：284.98 Kbytes 页数：16 Pages

TRIQUINT