PAM2863中文资料medium-voltage-dc-dc-led-drivers数据手册Diodes规格书

描述 Description

The PAM2863 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage. The device operates from an input supply between 4.5V and 40V and provides an externally adjustable output current of up to 2A. Depending upon supply voltage and external components, this can provide up to 30 watts of output power. The PAM2863 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. Output current can be adjusted below the set value, by applying an external control signal to the VSET pin. The VSET pin will accept either a DC voltage or a PWM waveform. The soft-start time can be increased using an external capacitor from the VSET pin to ground. Applying a voltage of 0.2V or lower to the VSET pin turns the output off and switches the device into a low current standby state.

特性 Features

Simple Low Parts Count
Internal 40V NDMOS Switch
2A Output Current
Single Pin On/Off and Brightness Control Using DC Voltage or PWM
Soft-Start
High Efficiency (up to 97%)
Wide Input Voltage Range: 4.5V to 40V
Output Shutdown
Open LED Protection
Short LED Protection
Up to 1MHz Switching Frequency
Typical 5% Output Current Accuracy
Pb-Free SOP-8(EP) Packages

应用 Application

High End LED Flashlight
LED Light Bar