Ultralow Power, Rail-to-Rail Output Operational Amplifiers

GENERAL DESCRIPTION The OP181, OP281 and OP481 are single, dual and quad ultralow power, single-supply amplifiers featuring rail-to-rail outputs. All operate from supplies as low as 2.0 V and are specified at +3 V and +5 V single supply as well as ±5 V dual supplies. FEATURES Low Supply

文件：448.07 Kbytes 页数：16 Pages

AD

亚德诺

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

GENERAL DESCRIPTION The AD8546 and AD8548 are dual and quad micropower, high input impedance amplifiers optimized for low power and wide operating supply voltage range applications. The AD8546/AD8548 rail-to-rail input/output (RRIO) feature provides increased dynamic range to drive low frequ

文件：963.34 Kbytes 页数：16 Pages

AD

亚德诺

22 μA, RRIO, CMOS, 18 V Operational Amplifier

FEATURES Micropower at high voltage (18 V): 22 μA maximum Low input bias current: 20 pA maximum Gain bandwidth product: 240 kHz at AV =100 typical Unity-gain crossover: 240 kHz −3 dB closed-loop bandwidth: 310 kHz Slew rate: 80 V/ms Large signal voltage gain: 110 dB minimum Single-supply operat

文件：709.49 Kbytes 页数：24 Pages

AD

亚德诺

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

FEATURES Low supply current: 4 μA/amplifier maximum Single-supply operation: 2.7 V to 12 V Wide input voltage range Rail-to-rail output swing Low offset voltage: 1.5 mV No phase reversal APPLICATIONS Comparator Battery-powered instrumentation Safety monitoring Remote sensors Low voltag

文件：396.26 Kbytes 页数：20 Pages

AD

亚德诺

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

文件：446.33 Kbytes 页数：20 Pages

AD

亚德诺

22 關A, RRIO, CMOS, 18 V

文件：696.47 Kbytes 页数：24 Pages

AD

亚德诺

MicroConverter짰 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU

文件：908.68 Kbytes 页数：88 Pages

AD

亚德诺

超低功耗、轨到轨输出运算放大器（双通道）

OP281和OP481分别是双通道和四通道、超低功耗、单电源放大器，具有轨到轨输出特性。各器件均可采用低至2.0 V的电源供电，额定电源电压为+3 V、+5 V（单电源）和±5 V（双电源）。\n\n OP281/OP481采用ADI的CBCMOS工艺制造，具有精密双极性输入，输出摆幅达到电源电压的数毫伏范围内，并且只要输出电压不大于电源电压，就可以持续提供吸电流或源电流。\n\n 具体应用包括安全监控、便携式设备、电池和电源控制，以及极低功耗系统中的传感器信号调理和接口。\n\n OP281/OP481具有轨到轨输出摆幅，将输出驱动至电源电压时无需提高电源电流， • 低电源电流：每个放大器4 μA（最大值）\n\n• 单电源供电：2.7 V至12 V\n\n• 宽输入电压范围\n\n• 轨到轨输出摆幅 \n\n• 低失调电压：1.5 mV\n\n• 无反相;

ADI

亚德诺

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

FEATURES Low supply current: 4 μA/amplifier maximum Single-supply operation: 2.7 V to 12 V Wide input voltage range Rail-to-rail output swing Low offset voltage: 1.5 mV No phase reversal APPLICATIONS Comparator Battery-powered instrumentation Safety monitoring Remote sensors Low voltag

文件：396.26 Kbytes 页数：20 Pages

AD

亚德诺

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

GENERAL DESCRIPTION The OP181, OP281 and OP481 are single, dual and quad ultralow power, single-supply amplifiers featuring rail-to-rail outputs. All operate from supplies as low as 2.0 V and are specified at +3 V and +5 V single supply as well as ±5 V dual supplies. FEATURES Low Supply

文件：448.07 Kbytes 页数：16 Pages

AD

亚德诺