Dual low-ohmic single-pole single-throw analog switch

文件：185.29 Kbytes 页数：20 Pages

恩XP

Dual low-ohmic single-pole single-throw analog switch

文件：320.83 Kbytes 页数：20 Pages

PHI

PHI

Dual low-ohmic single-pole single-throw analog switch

文件：185.29 Kbytes 页数：20 Pages

恩XP

Dual low-ohmic single-pole single-throw analog switch

文件：185.29 Kbytes 页数：20 Pages

恩XP

Dual low-ohmic single-pole single-throw analog switch

文件：185.29 Kbytes 页数：20 Pages

恩XP

双低电阻单刀双掷模拟开关

NX3L2T384是双路低电阻单刀单掷模拟开关。每个开关都具有两个输入/输出端子（nY和nZ）以及一个低电平有效使能输入(nE)。针脚nE为高电平时，模拟开关关闭。\n使能输入(nE)处的施密特触发器动作使电路容许较慢的输入上升和下降时间。低输入电压阈值使针脚nE能由较低电平逻辑信号驱动而不明显增大电源电流ICC。NX3L2T384因此能够使用1.8 V数字控制器切换4.3 V信号，无需逻辑电平转换。\nNX3L2T384允许振幅高达VCC的信号从nY传输到nZ；或从nZ传输到nY。其低导通电阻(0.5 Ω)和平坦度(0.13 Ω)确保最小衰减和传输信号失真。 1.4 V至4.3 V的宽电源电压范围\n极低导通电阻（峰值）： VCC = 1.4 V时，1.6Ω（典型值）\nVCC = 1.65 V时，1.0Ω（典型值）\nVCC = 2.3 V时，0.55 Ω（典型值）\nVCC = 2.7 V时，0.50 Ω（典型值）\nVCC = 4.3 V时，0.50 Ω（典型值）\n\n高抗噪性\nESD保护： HBM JESD22-A114F 3A类超过7500 V\nMM JESD22-A115-A超过200 V\nCDM AEC-Q100-011修订版B超过1000 V\nIEC61000-4-2接触放电超过4000 V（适合开关端口）\n\nCMOS;

恩XP

Dual low-ohmic single-pole double-throw analog switch

Archived content is no longer updated and is made available for historical reference only.\nThe NX3L2T384 is a dual low-ohmic single-pole single-throw analog switch. Each switchhas two input/output terminals (nY and nZ) and an active LOW enable input (nE). Whenpin nE is HIGH, the analog switch is tu Wide supply voltage range from 1.4 V to 4.3 V\nVery low ON resistance (peak): 1.6 Ω (typical) at VCC = 1.4 V\n1.0 Ω (typical) at VCC = 1.65 V\n0.55 Ω (typical) at VCC = 2.3 V\n0.50 Ω (typical) at VCC = 2.7 V\n0.50 Ω (typical) at VCC = 4.3V\nHigh noise immunity\nESD protection: HBM JESD22-A114F Class;

恩XP