Dual low-ohmic single-pole single-throw analog switch

文件：155.09 Kbytes 页数：20 Pages

恩XP

Dual low-ohmic single-pole single-throw analog switch

文件：323.87 Kbytes 页数：21 Pages

PHI

飞利浦

Dual low-ohmic single-pole single-throw analog switch

文件：155.09 Kbytes 页数：20 Pages

恩XP

Dual low-ohmic single-pole single-throw analog switch

文件：155.09 Kbytes 页数：20 Pages

恩XP

Dual low-ohmic single-pole single-throw analog switch

文件：155.09 Kbytes 页数：20 Pages

恩XP

双低电阻单刀单掷模拟开关

NX3L2G384是双路低电阻单刀单掷模拟开关。每个开关都具有两个输入/输出端子（nY和nZ）以及一个低电平有效使能输入(nE)。针脚nE为高电平时，模拟开关关闭。\n使能输入(nE)处的施密特触发器动作使电路容许较慢的输入上升和下降时间。NX3L2G384允许振幅高达VCC的信号从nY传输到nZ；或从nZ传输到nY。其低导通电阻(0.5 Ω)和平坦度(0.13 Ω)确保最小衰减和传输信号失真。 1.4 V至4.3 V的宽电源电压范围\n极低导通电阻（峰值）： VCC = 1.4 V时，1.6Ω（典型值）\nVCC = 1.65 V时，1.0Ω（典型值）\nVCC = 2.3 V时，0.55 Ω（典型值）\nVCC = 2.7 V时，0.50 Ω（典型值）\nVCC = 4.3 V时，0.50 Ω（典型值）\n\n高抗噪性\nESD保护： HBM JESD22-A114F 3A类超过7500 V\nMM JESD22-A115-A超过200 V\nCDM AEC-Q100-011修订版B超过1000 V\nIEC61000-4-2接触放电超过4000 V（适合开关端口）\n\nCMOS;

恩XP

恩智浦

Dual low-ohmic single-pole single-throw analog switch

The NX3L2G384 is a dual low-ohmic single-pole single throw analog switch. Each switchhas two input/output terminals (nY and nZ) and an active LOW enable input (nE). Whenpin nE is HIGH, the analog switch is turned off.\nSchmitt trigger action at the enable input (nE) makes the circuit tolerant to slo Wide supply voltage range from 1.4 V to 4.3 V\nVery low ON resistance (peak): 1.6 Ω (typical) at VCC = 1.4 V\n1.0 Ω (typical) at VCC = 1.65 V\n0.55 Ω (typical) at VCC = 2.3 V\n0.50 Ω (typical) at VCC = 2.7 V\n0.50 Ω (typical) at VCC = 4.3 V\nHigh noise immunity\nESD protection: HBM JESD22-A114F Clas;

恩XP

恩智浦