Low-ohmic single-pole double-throw analog switch

文件：502.84 Kbytes 页数：23 Pages

恩XP

Low-ohmic single-pole double-throw analog switch

文件：336.45 Kbytes 页数：24 Pages

PHI

飞利浦

Low-ohmic single-pole double-throw analog switch

文件：502.84 Kbytes 页数：23 Pages

恩XP

Low-ohmic single-pole double-throw analog switch

文件：502.84 Kbytes 页数：23 Pages

恩XP

Low-ohmic single-pole double-throw analog switch

文件：502.84 Kbytes 页数：23 Pages

恩XP

低电阻单刀双掷模拟开关

NX3L1G53是低电阻单刀双掷模拟开关，适合用作模拟或数字2:1多路复用器/多路解复用器。其具有一个数字选择输入(S)、两个独立的输入/输出（Y0和Y1）、一个公用输入/输出(Z)和一个有源低电平使能输入(E)。引脚E为高电平时，开关关闭。施密特触发器在数字输入处工作，这使得电路容许较慢的输入上升和下降时间。\nNX3L1G53允许具有高达VCC振幅的信号从Z传输到Y0或Y1；或从Y0或Y1传输到Z。其低导通电阻(0.5 Ω)和平坦度(0.13 Ω)确保传输的信号具有最小衰减和失真。 宽电源电压范围从1.4 V至4.3 V\n极低的导通电阻（峰值）： VCC = 1.4 V时为1.6 Ω（典型值）\nVCC = 1.65 V时为1.0 Ω（典型值）\nVCC = 2.3 V时为0.55 Ω（典型值）\nVCC = 2.7 V时为0.50Ω（典型值）\nVCC = 4.3 V时为0.50 Ω（典型值）\n\n先断后通切换\n高抗噪性\nESD保护： HBM JESD22-A114F 3A类超过7500 V\nMM JESD22-A115-A超过200 V\nCDM AEC-Q100-011修订版B超过1000 V\n开关端口的IEC61000-4-2接触放电超过8000 V\;

恩XP

Low-ohmic single-pole double-throw analog switch

The NX3L1G53 is a low-ohmic single-pole double-throw analog switch suitable for use asan analog or digital 2:1 multiplexer/demultiplexer. It has a digital select input (S), twoindependent inputs/outputs (Y0 and Y1), a common input/output (Z) and an active LOWenable input (E). When pin E is HIGH, the Wide supply voltage range from 1.4 V to 4.3 V\nVery low ON resistance (peak): 1.6 Ω (typical) at VCC = 1.4 V\n1.0 Ω (typical) at VCC = 1.65 V\n0.55 Ω (typical) at VCC = 2.3 V\n0.50 Ω (typical) at VCC = 2.7 V\n0.50 Ω (typical) at VCC = 4.3 V\nBreak-before-make switching\nHigh noise immunity\nESD prot;

恩XP