NT7501H-BDT中文资料ETC数据手册PDF规格书

[Novatek]

General Description

The NT7501 is a single-chip LCD driver for dot-matrix liquid crystal displays, which is directly connectable to a microcomputer bus. It accepts 8-bit serial or parallel display data directly sent from a microcomputer and stores it in an on-chip display RAM. It generates a LCD drive signal independent of the microprocessor clock.

The set of the on-chip display RAM of 65 X 132 bits, and a one-to-one correspondence between the LCD panel pixel dots and the on-chip RAM bits, permits implementation of displays with a high degree of freedom.

As a total of 133 circuits of common and segment outputs are incorporated, a single chip of NT7501 can make 33 X 100 dots displays.

No external operation clock is required for RAM read/write operations. Accordingly, this driver can be operated with minimum current consumption and its on-board low-current consumption liquid crystal power supply can implement a high-performance handy display system with minimal current consumption and a minute LSI configuration.

Features

■ Direct RAM data display using the display RAM. When RAM data bit is 0, it is not displayed. When RAM data bit is 1, it is displayed. (In normal display mode)

■ RAM capacity: 65 X 132 = 8580 bits

■ Many command functions: Read/Write Display Data, Display ON/OFF, Normal/Reverse Display, Page Address Set, Set Display Start Line, Set LCD Bias, Electronic contrast Controls, Read Modify Write, Select Segment Driver Direction and Power Save

■ High-speed 8-bit microprocessor interface allowing direct connection to both the 8080 and 6800

■ Serial interface

■ Single supply operation, 2.4 - 3.5V

■ Maximum 9V LCD driving output voltage

■ 2X / 3X / 4X on chip DC-DC converter

■ Voltage regulator

■ Voltage follower (LCD bias: 1/5 or 1/6)

■ On chip oscillator