1.8 Volt Rail-to-Rail Operational Amplifier

The NCS7101 operational amplifier provides rail−to−rail operation on both the input and output. The output can swing within 50 mV of each rail. This rail−to−rail operation enables the user to make full use of the entire supply voltage range available. It is designed to work at very low supply

文件：271.58 Kbytes 页数：17 Pages

ONSEMI

安森美半导体

Operational Amplifier, Low bias current, Rail to Rail CMOS Op-Amp

The NCS7101 op-amp provides rail-to-rail operation on both the input and output. The output can swing within 50 mV of each rail. This rail-to-rail operation enables the user to make full use of the entire supply voltage range available. It is designed to work at very low supply voltages (1.8 V and g Low Voltage, Single Supply Operation (1.8 V and Ground to 10 V and Ground)\n1.0 pA Input Bias Current\nUnity Gain Bandwidth of 1.0 MHz at 5.0 V, 0.9 MHz at 1.8 V\nOutput Voltage Swings Within 50 mV of Both Rails @ 1.8 V\nNo Phase Reversal on the Output for Over-Driven Input Signals\nInput Offset Tri;

ONSEMI

安森美半导体

1.8 Volt Rail-to-Rail Operational Amplifier

The NCS7101 operational amplifier provides rail−to−rail operation on both the input and output. The output can swing within 50 mV of each rail. This rail−to−rail operation enables the user to make full use of the entire supply voltage range available. It is designed to work at very low supply

文件：271.58 Kbytes 页数：17 Pages

ONSEMI

安森美半导体

1.8 Volt Rail-to-Rail Operational Amplifier

The NCS7101 operational amplifier provides rail−to−rail operation on both the input and output. The output can swing within 50 mV of each rail. This rail−to−rail operation enables the user to make full use of the entire supply voltage range available. It is designed to work at very low supply

文件：271.58 Kbytes 页数：17 Pages

ONSEMI

安森美半导体

1.8 Volt Rail-to-Rail Operational Amplifier

文件：192.55 Kbytes 页数：16 Pages

ONSEMI

安森美半导体

1.8 Volt Rail-to-Rail Operational Amplifier

文件：192.55 Kbytes 页数：16 Pages

ONSEMI

安森美半导体