NCP1612A2集成电路（IC）的PFC（功率因数校正）规格书PDF中文资料

NCP1612A2属于集成电路（IC）的PFC（功率因数校正）。由安森美半导体公司制造生产的NCP1612A2PFC（功率因数校正）功率因数校正 (PFC) 是用于调整交流电路中的电压和电流之间的相位角，使之趋近于零的半导体器件。不同模式包括平均电流、边界导通、连续导通、临界导通、电流控制式频率折返、不连续和不连续导通，开关频率从 6 kHz 至 1.7 MHz 可调。

The NCP1612 is designed to drive PFC boost stages based on an innovative Current Controlled Frequency Fold-back (CCFF) method. In this mode, the circuit classically operates in Critical conduction Mode (CrM) when the inductor current exceeds a programmable value. When the current is below this preset level, the NCP1612 linearly decays the frequency down to about 20 kHz when the current is null. CCFF maximizes the efficiency at both nominal and light load. In particular, the stand-by losses are reduced to a minimum.

General Features

• Near-unity Power Factor

• Critical Conduction Mode (CrM)

• Current Controlled Frequency Fold-back (CCFF): Low Frequency Operation is Forced at Low Current Levels

• On-time Modulation to Maintain a Proper Current Shaping in CCFF Mode

• Skip Mode Near the Line Zero Crossing

• Fast Line/Load Transient Compensation (Dynamic Response Enhancer)

• Valley Turn On

• High Drive Capability: −500 mA/+800 mA

• VCC Range: from 9.5 V to 35 V

• Low Start-up Consumption

• Six Versions: NCP1612A, B, A1, A2, A3 and B2 (see Table 1)

• Line Range Detection

• pfcOK Signal

• This is a Pb-Free Device

Safety Features

• Separate Pin for Fast Over-voltage Protection (FOVP) for Redundancy

• Soft Over-voltage Protection

• Brown-out Detection

• Soft-start for Smooth Start-up Operation (A, A1, A2 and A3 Versions)

• Over Current Limitation

• Disable Protection if the Feedback is Not Connected

• Thermal Shutdown

• Latched Off Capability

• Low Duty-cycle Operation if the Bypass Diode is shorted

• Open Ground Pin Fault Monitoring

• Saturated Inductor Protection

• Detailed Safety Testing Analysis (Refer to Application Note AND9079/D)

Typical Applications

• PC Power Supplies

• All Off Line Appliances Requiring Power Factor Correction