NCA9539PW-Q100中文资料安世数据手册PDF规格书

General description

The NCA9539-Q100 provides 16 bits of General Purpose Input/Output (GPIO) expansion with

interrupt and reset for I²C-bus/SMBus applications. It is designed for a wide voltage range of

1.65 V to 5.5 V. Nexperia GPIO expanders provide an elegant solution when additional IOs are

needed while keeping the interconnections to a minimum, for example, in ACPI power switches,

sensors, push buttons, LEDs and fan control. The NCA9539-Q100 contains a set of 8 bit input,

output, configuration and polarity inversion registers. At power up all IOs default to inputs. Each IO

can be configured as either input or output by changing the corresponding bit in the configuration

register. The data for each input or output is stored in the corresponding input or output register.

The polarity inversion register can be programmed to invert the polarity of the read register. The

NCA9539-Q100 has an open-drain interrupt output which is activated when any one of the GPIO

changes from its corresponding input port register state. INT can be connected to the interrupt

input of a microcontroller. By sending an interrupt signal on this line, the remote I/O can inform the

microcontroller if there is incoming data on its ports without having to communicate via the I²Cbus.

Thus, NCA9539-Q100 can remain a simple slave. The power on reset sets the registers to

default values and initializes the device state machine. The RESET pin can be used to achieve

same reset functionality without power down/up cycling by keeping active low. The state machine

and the registers are in their default state until the RESET input is once again HIGH. This input

requires pull up to VCC. The NCA9539-Q100 has two address pins A0 and A1 which can be used

to configure the I²C bus slave address of the device. It allows up-to four devices to share the same

I²C-bus/SMBus.

This product has been qualified to the Automotive Electronics Council (AEC) standard Q100

(Grade 1) and is suitable for use in automotive applications.

Features and benefits

• Automotive product qualification in accordance with AEC-Q100 (Grade 1)

• Specified from -40 °C to +125 °C

• I²C-bus to parallel port expander

• Operating power supply voltage range of 1.65 V to 5.5 V

• Low standby current consumption:

• 4 μA (maximum)

• Schmitt-trigger action allows slow input transition and better switching noise immunity at the

SCL and SDA inputs

• Vhys = 0.10 × VCC (typical)

• Noise filter on SCL and SDA inputs

• 5 V tolerant I/Os

• 16 I/O pins which power up configured in input state

• Open-drain active LOW interrupt output (INT)

• Reset input for resetting NCA9539-Q100 to default values (RESET)

• 400 kHz Fast-mode I²C-bus

• Internal power-on reset

• No glitch on power-up

• Latched outputs with 25 mA drive maximum capability for directly driving LEDs

• Latch-up performance exceeds 100 mA per JESD78, Class II

• ESD protection:

• HBM ANSI/ESDA/JEDEC JS-001 Class 2 exceeds 2000 V

• CDM ANSI/ESDA/JEDEC JS-002 Class C3 exceeds 1000 V

• Packages offered: TSSOP24