General Description

The MCP14A0051/2 devices are high-speed MOSFET

drivers that are capable of providing up to 0.5A of peak

current while operating from a single 4.5V to 18V

supply. The inverting (MCP14A0051) or noninverting

(MCP14A0052) single-channel output is directly

controlled from either TTL or CMOS (2V to 18V) logic.

These devices also feature low shoot-through current,

matched rise and fall times and short propagation

delays, which make them ideal for high switching

frequency applications.

The MCP14A0051/2 family of devices offers enhanced

control with enable functionality. The active-high

Enable (EN) pin can be driven low to drive the output of

the MCP14A0051/2 low, regardless of the status of the

Input (IN) pin. An integrated pull-up resistor allows the

user to leave the Enable pin floating for standard

operation.

Additionally, the MCP14A0051/2 devices feature separate

ground pins (AGND and GND), allowing greater

noise isolation between the level-sensitive Input/

Enable pins and the fast, high-current transitions of the

push-pull output stage.

These devices are highly latch-up resistant under any

condition within their power and voltage ratings. They

can accept up to 500 mA of reverse current being

forced back into their outputs without damage or logic

upset. All terminals are fully protected against

Electrostatic Discharge (ESD) up to 1.75 kV (HBM) and 100V (MM).

Features

• High Peak Output Current: 0.5A (typical)

• Wide Input Supply Voltage Operating Range:

- 4.5V to 18V

• Low Shoot-Through/Cross-Conduction Current in

Output Stage

• High Capacitive Load Drive Capability:

- 1000 pF in 40 ns (typical)

• Short Delay Times: 33 ns (tD1), 24 ns (tD2) (typical)

• Low Supply Current: 375 μA (typical)

• Low Voltage Threshold Input and Enable with

Hysteresis

• Latch-up Protected: Withstands 500 mA Reverse

Current

• Space-Saving Packages:

- 6-Lead SOT-23

- 6-Lead 2x2 DFN

Applications

• Switch Mode Power Supplies (SMPS)

• Pulse Transformer Drive

• Line Drivers

• Level Translator

• Motor and Solenoid Drive

MCP14A0052属于集成电路（IC） > 栅极驱动器。微芯科技股份有限公司制造生产的MCP14A0052栅极驱动器栅极驱动器电源管理集成电路 (PMIC) 可用于提供隔离、放大、参考位移、自举或其他必要功能，这些功能可将来自电源转换应用中控制设备的信号连接到电源被控制通过的半导体设备（通常为 FET 或 IGBT）。任何特定设备提供的确切功能各不相同，但与它适合驱动的半导体配置相关。